Furniture of America CM-BK524 User manual

1. Insert 2 barrel nuts (#I) into the holes along the sides of the lower front/back side
rails (#6), then align the ends of those side rails to the lower end guardrails (#3).
2. Insert 2 bolts (#A) into the lower end
guardrails (#3) to connect with the
rails. Secure using the Allen wrench (#L).
Place the slats (#9) onto the side rails,
then insert a screw (#E) into each end
and secure using a Phillips screwdriver.

1. Insert 2 barrel nuts (#I) into the ends of the
upper front side rails (#4,5) , 1 barrel nut into
the ends of the back guard rails (#7), and 1
barrel nut into one end of the front guardrails
(#8) with the openings facing the hole.
2. Align each end to the upper
end guardrails (#1,2).
3. Insert a bolt (#A) into each hole
along the upper end guardrails
(#1,2) to connect with the rails.
Secure using the Allen wrench (#L).
/
$
1. Align the guardrail supports (#11)
to the inner holes along the rails,
then insert 3 screws (#E) into each
and secure using a screwdriver.
2. Insert 2 wood dowels (#H) into
end of the front guardrails (#8),
then apply the guardrail bar (#10)
onto the other end of those dowels.
3. Insert 2 screws (#D) into the side
of the guardrail bar (#10) and 2
bolts (#B) into the bottom. Secure
using a screwdriver and wrench (#L).

1. Align (#J) to each end, then insert
2 screws (#F) into the two top holes
and secure using a Phillips screwdriver.
2. Prepare 4 bolt assemblies by
inserting a washer (#K) onto
the bolts (#C). Insert and bolt
into each end. Secure using
the Allen wrench (#L).
Place the slats (#9) onto the side rails,
then insert a screw (#E) into each end
and secure using a Phillips screwdriver.

Insert a metal dowel (#G) into the
holes along the top of the lower
bed. Then carefully place the top
bed onto those metal dowels.
1. Align each end the ladder rungs (#14) to the left and right ladder rails (#12,13).
2. Insert a screw (#D) into each hole along the ladder
rails and secure using a Phillips screwdriver.

Hook the top of the ladder,
then insert a screw (#F) into
each hook and secure using
a Phillips screwdriver.
Make sure all parts are firmly secured.