Furniture of America CM-BK603 User manual

Rev: 15-07-23

Ladder Steps

1. With the help of another person, hold the
lower end guardrails (#1) upright and align
the lower side rails (#3) to the pre-drilled
holes along the sides of those guardrails.
2a. Insert 2 barrel nuts (#B)
into each end of the lower
side rails (#3)
2b. Then insert 2 bolts (#A) into
the lower end guardrails (#1)
to lock with the rails. Secure
using the Allen wrench (#I).
Align a support leg (#8) to the pre-drilled hole along the center
of a slat (#6). Insert a screw (#F) from above and secure using
a Phillips screwdriver. Repeat process on a a second slat.

Place the full slat kit (#7) onto the lower side rails (#3). Align the ends of the
slats to the pre-drilled holes located on the inner side of the lower side rails (#3).
Insert a screw (#C) into each end and secure using a Phillips screwdriver.
1. With the help of another person, hold
the upper end guardrails (#2) upright
and align the guardrails (#5) to the top
2 pre-drilled holes and the upper side
rail (#4) to the bottom holes along the
sides of those guardrails (#2).
2a. Insert the barrel nuts (#B) into
each end of the rails (#4,5).
2b. Then insert 2 bolts (#A) into the upper
end guardrails (#2) to lock with the rails,
then secure using the Allen wrench (#I).

1. Align the guardrail supports (#10) to the
pre-drilled holes located along the sides
of the upper side rails (#4) and guardrails
(#5). Insert a total of 6 bolts (#D) and
secure using the Allen wrench (#I).
2. Apply the center support (#9) onto
the slots located along the inner sides
of the upper end guardrails (#2). Insert
a screw (#C) into each end and secure
using a Phillips screwdriver.
Place the full slat kit (#6) onto the upper
side rails (#4). Align the ends of the slats
to the pre-drilled holes located on the
inner side of the upper side rails (#4).
Insert a screw (#C) into each end and
secure using a Phillips screwdriver.
#4

Insert a metal dowel (#G) into the large
pre-drilled holes located on top of the
lower end guardrails (#1). With the help of
another person carefully place the upper
bunk bed onto those metal dowels (#G).
Insert the ends of the ladder steps (#11) into the designated slots
along the side of the ladder rails (#12,13). Insert 4 screws (#E)
into each ladder rail and secure using the Allen wrench (#I).
Note: Left and right is
determined by facing
the front of the ladder
in its upright position.

Hook the top of the ladder rails onto the upper
side rail (#4). Locate the pre-drilled holes on
the inner side then align and insert 2 screws
(#H).Secure using a Phillips screwdriver.
ASSEMBLY IS COMPLETED
Page 10 of 11