Furniture of America CM3615SC-2PK-KD User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM3615SC-2PK-KD
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-10-21
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
Phillips Screwdriver
(Not Included)

Page 2 of 5

Parts List
#1 x 2 pcs
Left Front Leg
#2 x 2 pcs
Right Front Leg
#3 x 2 pcs
Backrest w/Legs
#A x 12 pcs
Bolt 1/4”x3/4”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
MD
Page 3 of 5
Hardware List
#C x 1 pc
Allen Wrench
#B x 8 pcs
Screw
#4 x 2 pcs
Front Leg Support
#5 x 2 pcs
Seat
X 2

Page 4 of 5
I. Align the assembled left front
leg (#1) and the right front
leg (#2) with the pre-drilled
holes on the backrest with
legs (#3).
II. Secure 4 screws (#A)
through the brackets of the
left front leg (#1) and the
right front leg (#2) using the
Allen wrench (#C) to secure
them to the backrest with
legs (#3).
#A x 4 pcs
I. Align the front leg support
(#4) with the pre-drilled
holes of the left front leg (#1)
and the right front leg (#2).
II. Insert 2 bolts (#A) through
the left front leg (#1) and the
right front leg (#2) using the
Allen wrench (#C) to secure
them with the front leg
support (#4).
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
#A x 8 pcs
Note: Right and left are determined by facing
the front of the chair in the upright position.

Page 5 of 5
#B x 8 pcs
ASSEMBLY IS COMPLETED
Make sure the chairs are rested on a flat surface and do not feel
loose or wobbly. If they do, double check that the bolts/screws
are secured and properly tightened.
I. Align the seat (#5) with the
pre-drilled holes on the left
front leg (#1) and the right
front leg (#2).
II. Secure 4 screws (#B)
through bottom of the left
front leg (#1) and the right
front leg (#2) using the
Phillips screwdriver to
secure them with the seat
(#5).
Turn right (clockwise) to tighten
X 2