Furniture of America CM-BK608T User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-09-24
Page 1 of 10
DIFFICULT
ASSEMBLY RATING
CM-BK608T
2 PERSONS RECOMMENDED
Phillips Screwdriver (Not Included)

Page 2 of 10

#4 x 1 pc
Lower Rear Side Rail
Parts List
#1 x 2 pcs
Lower End G/Rail
#3 x 1 pc
Upper Rt. End G/Rail
#7 x 1 pc
Upper Front Side Rail
Before you begin, please read Page 2
for “Assembly and Care Advice” AND
Page 10 for “Safety Warnings”.
And remember, do not tighten until
each step is completed or instructed.
MD
Page 3 of 10
#9 x 2 pcs
Front Guardrail
#6 x 1 pc
Upper Rear Side Rail
#10 x 2 pcs
Guardrail Support
#2 x 1 pc
Upper Lt. End G/Rail
#5 x 1 pc
Lower Front Side Rail
#8 x 2 pcs
Rear Guardrail
#11 x 1 pc
Right Ladder Rail
#14 x 2 sets
Twin Slat Kit
#13 x 4 pcs
Ladder Rung
#12 x 1 pc
Left Ladder Rail

#D x 6 pcs
Bolt 1/4”x1-9/16”
Hardware List
#A x 22 pcs
Bolt 1/4”x4-1/4”
#C x 6 pcs
Bolt 1/4”x1-3/16”
#I x 1 pc
Allen Wrench
Page 4 of 10
#F x 24 pcs
Screw 3/16”x1-3/16”
#B x 22 pcs
Barrel Nut
#E x 8 pcs
Screw 5/16”x2”
#H x 4 pcs
Wood Dowel 90mm
Due to the size and/or weight of this product, it
is highly recommended that the assembly
should be done near the area of its intended
location. Make sure you have enough space to
move around during the assembly. ALWAYS
have at least two people to help with
transporting and assembling the product to
avoid any potential injury and/or damage.
#G x 12 pcs
Wood Dowel 40mm
Note: Right and left are
determined by facing the
ladder of the bunk bed in its
upright position.

Page 5 of 10
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
#A x 8 pcs
#B x 8 pcs
#A x 12 pcs
#B x 12 pcs
#G x 8 pcs

Page 6 of 10
Turn right (clockwise) to tighten
#A x 2 pcs
#B x 2 pcs
#C x 6 pcs
#G x 4 pcs
#H x 4 pcs

Page 7 of 10
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
#F x 8 pcs
#E x 8 pcs

Page 8 of 10
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
#D x 6 pcs
#F x 8 pcs

Page 9 of 10
Turn right (clockwise) to tighten
ASSEMBLY IS COMPLETED
Safety is ALWAYS the main priority. Please take the time to
inspect the assembly and FULLY tighten all bolts/screws.
Read and follow the
information on the
WARNINGS shown on the end
structure of the upper bunk
and on the carton. Do not
remove warning label from the
bed. Keep these instructions
for future reference.
#F x 8 pcs
Must use Bunkie mattress or
Bunkie board (sold separately).

Page 10 of 10
Safety Warnings for Bunk Beds
1. Read and follow the information on the WARNINGS shown on the end
structure of the upper bunk and on the carton. Do not remove warning label
from the bed. Keep these instructions for future reference.
2. IMPORTANT: Must use Bunkie mattress or Bunkie board. The safety
sizes for the UPPER/LOWER TWIN-SIZE Bunkie mattress or board should
be 74” - 75” long and 37½” - 38½” wide with no more than 6” thickness. The
safety sizes for the UPPER/LOWER FULL-SIZE Bunkie mattress or board
must be 74” - 75” long and 53” - 54” wide with no more than 6” thickness.
3. Surface of mattress must be at least 5 inches (127 mm) BELOW the upper
edge of guardrails.
4. The MAXIMUM weight capacity for the upper bunk is not to exceed 150 lbs.
5. Do not allow persons under 6 years of age to use the upper bunk.
6. Periodically check and ensure that the guardrails, ladder, handle and other
components are in their proper position, free from damage, and that all
connectors are tightened and secured.
7. For safety reasons, especially on the upper bunk bed, DO NOT allow rough
playing or jumping on the bed and do not allow playing or hiding under the
bed.
8. Always use the ladder for entering and leaving the upper bunk.
9. Do not use substitute parts. Contact the manufacturer or dealer for
replacement parts.
10. Use of a nightlight may provide added safety precaution for a person using
the upper bunk.
11. Always use the guardrails on both long sides of the upper bunk. If the bunk
bed will be placed next to the wall, the guardrail that runs the full length of
the bed should be placed against the wall to prevent entrapment between
the bed and the wall.
12. The use of water or sleep flotation mattresses is prohibited.
13. No more than one person is allowed on the upper bunk at all times.
WARNING:
STRANGULATION HAZARD
Never attach or hang objects to any part of the bunk bed
that are not designed for use with the bed. Objects such as
hanger, hook, belt, bag, rope, string, etc. should not be used
on or around the bunk bed.