Furniture of America CM7302Q User manual

Rev: 18-01-11

#G x 4pcs
Wood en Dow el 10*40mm

Prepare 8 bolts assembly by inserting lock washer
(#B), then flat washer (#C) onto bolts (#A).
Attach dowels (#G) to the holes of the HB legs
(#2R/L), then align HB legs (#2R/L) to the HB
panel (#1) and HB support (#3). Secure by using
bolts (#A).
1) Align bottom frame (#5) to the
holes of the footboard (#4), then
secure by using bolts (#D) with
washers (#E).
2) Attach support legs (#13) to the holes of
the bottom frame (#5).
3) Attach support legs (#12)
to the holes of the bottom
frame (#5).

Attach threaded studs (#J) to the holes of the headboard (#1) and footboard (#4), then
align side rails (#6R/L) to the threaded studs (#J). Secure by using washer (#K) with
hex nut (#L).
Align rail drawer support slats (#7) to the side rails (#6R/L),
then secure by using screws (#H).

# 6L
# 6R
#14
#H
Align and attach support legs (#11) to the holes of the center slats (#8) and bed slats (#14).
Adjust the leveler on the support legs (#11) according to ground level.
Place bed slats (#14) to the side rails, then
secure by using screws (#H).

Attach drawers (#9,10) to the drawer slat rails.

Rev: 18-01-11

#G x 4pcs
Wooden Dowel 10*40mm

Prepare 8 bolts assembly by inserting lock washer
(#B), then flat washer (#C) onto bolts (#A). Attach
dowels (#G) to the holes of the HB legs (#2R/L),
then align HB legs (#2R/L) to the HB panel (#1)
and HB support (#3). Secure by using bolts (#A).

1) Align bottom frame (#5) to the
holes of the footboard (#4), then
secure by using bolts (#D) with
washers (#E).
2) Attach support legs (#13) to the holes
of the bottom frame (#5).
3) Attach support legs (#12) to the
holes of the bottom frame (#5).
Attach threaded studs (#J) to the holes of the headboard (#1) and footboard (#4), then align side
rails (#6R/L) to the threaded studs (#J). Secure by using washer (#K) with hex nut (#L).

Align rail drawer support slats (#7) to the side rails (#6R/L),
then secure by using screws (#H).
Align and attach support legs (#11) to the holes of the center slats (#8) and bed slats (#14).
Adjust the leveler on the support legs (#11) according to ground level.

#14
Place bed slats (#14) to the side rails, then secure
by using screws (#H).
Attach drawers (#9,10) to the drawer slat rails.

Align top side rails (#15) to the upper holes of the side rails (#6). Secure by using bolts (#D).

Rev: 18-01-11

#G x 4pcs
Wood en Dow el 10*40mm