Furniture of America CM3615T-48 User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Assembly Instructions
Tools Required for Assembly
Rev.16-09-08
Page 1 of 4
DIFFICULT
ASSEMBLY RATING
CM3615T-48
2 PERSONS RECOMMENDED
Allen Wrench
Phillips Screwdriver
(Included)
(Not Included)
For more information contact our team: [email protected]

Page 2 of 4

Parts List Hardware List
#1 x 2 pcs
Leg Stand
#2 x 1 pc
Table Top
#3 x 2 pcs
Apron
#A x 16 pcs
Bolt 1/4”x5/8”
#B x 10 pcs
Screw
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 1 pc
Allen Wrench
MD
Page 3 of 4
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly. ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage.

Page 4 of 4
I. With the help of another
person, carefully place the
table top (#2) facing down on
a protected surface.
II. Align the assembled leg
stands (#1) with the table
top (#2)(no pre-drilled holes).
III. Secure 6 screws (#B) through
the leg stands (#1) and 4
screws (#B) through the
aprons (#3) using a Phillips
screwdriver to secure them
with the table top (#2).
IV. Carefully place the completed
table upright. Make sure the
table is rested on a flat surface
and does not feel loose or
wobbly. If it does, double
check that the bolts/screws
are secured and properly
tightened.
#A x 16 pcs
I. Align the 2 aprons (#3) with the
brackets of the leg stand (#1).
II. For each bracket of the leg
stand (#1), insert 2 bolts (#A)
through the bottom of the
bracket and 2 bolts (#A)
through the back of the bracket
using the Allen wrench (#C) to
secure them with the apron
(#3).
III. Repeat the process above to
assemble the other leg stand
(#1) onto the other ends of the
2 aprons (#3).
Turn right (clockwise) to tighten
ASSEMBLY IS COMPLETED
Turn right (clockwise) to tighten
#B x 10 pcs
Insert each end of the aprons (#3)
onto the leg stands (#1), then insert
the bolts (#A) into each hole. Secure
using the Allen wrench (#C).
1. Carefully place the table top (#2)
face down onto a protected surface.
2. Align the top of the leg stands (#1)
and aprons (#3) to the table top.
3. Use a power tool to secure screws
(#B). If using a screwdriver: use a
light hammer to tap on the screw,
then secure using the screwdriver.
Note: No pre-drilled holes created.
ASSEMBLY IS COMPLETED