Furniture of America CM3984DK-PC-2PK User manual

I. Place the backrest with legs (#1) on a protected surface.
Align the seat (#2) with the pre-drilled holes of the backrest
with legs (#1).
II. Prepare a bolt assembly by inserting FIRST the lock washer
(#D) onto the bolt (#C) and then the flat washer (#E) onto the
SAME bolt (#C), in that order.
III. Insert the bolt assembly through one of the
pre-drilled holes in the center of the seat (#2)
and secure the bolt using the Allen
wrench (#F) to lock it with the backrest with legs (#3).
Repeat the process with second bolt.
Note: Right and left are determined
by facing the FRONT of the chair
in its upright position.
I. Prepare 4 bolt assemblies by
inserting FIRST the lock
washer (#D) onto the bolt
(#A) and then the flat washer
(#E) onto the SAME bolt
(#A), in that order.
II. Insert the bolt assemblies
through the pre-drilled holes
in the corners of the seat (#2)
and secure those bolts using
the Allen wrench (#F) to lock
them onto the backrest with
legs (#1).

I. Prepare 4 bolt assemblies by inserting FIRST the lock washer (#D) onto the bolt (#B) and then the
flat washer (#E) onto the SAME bolt (#B), in that order.
II. Insert the bolt assemblies through the pre-drilled holes in the corners of the seat (#2) and secure
those bolts using the Allen wrench (#F) to lock
them with the front left leg (#3)
and front right leg (#4).
I. Attach the leg supports in the designated slots along the legs.
II. Insert the wood screw (#G) at a diagonal using a Phillips screwdriver.
Tighten screws until properly secure.
ASSEMBLY IS COMPLETED