Furniture of America CM7090Q User manual

1. Carefully place the head-
board (#1) face down onto
a protected surface. Then
align the legs (#2R/L) to
the holes along the sides
of the headboard (#1).
2. Prepare 8 bolt assemblies
by inserting a lock washer
(#C) onto the bolt (#A) then
a flat washer (#D) onto that
same bolt (#A). Insert 4 into
each leg and secure using
the Allen wrench (#E).
3. Align the h/board leg rail (#3)
to the holes along the sides of
the legs. Prepare 4 bolt
assemblies by inserting a lock
washer (#C) onto the bolt (#B)
then a flat washer (#D) onto
that same bolt (#B). Insert 3
into each leg and secure using
the Allen wrench.
1. Insert the threaded
studs (#F) into the
holes along the
h/board legs and
footboard. Turn
right to tighten.
2. Apply the side rails (#5) onto those threaded studs (#F). Then
apply a hex nut (#G) onto each stud and secure using the wrench.

6
Adjust the leveler accordingly.
Insert the threaded ends of the slat
support leg (#7) into the holes along
the slats (#6). Turn right to tighten.
Place the slats (#6) onto the
side rails and align the holes.
Insert a screw (#I) into each
end and secure using a
Phillips screwdriver.