Furniture of America CM7296M User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM7296M
Assembly Instructions
Tools Required for Assembly:
Rev.14-04-17
Page 1 of 4
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED
Allen Wrench (Included)
CM7267D
DRESSER AND MIRRORARE SOLD AND PACKED SEPARATELY

Page 2 of 4

Parts List
#1 x 1 pc
Mirror
#2 x 1 pc
Dresser
#3 x 2 pcs
Mirror Support Bracket
#A x 8 pcs
Bolt 1/4”x1-1/2”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly. ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage, especially
with the fragile nature of the mirror.
MD
Page 3 of 4
Hardware List
#4 x 1 pc
Center Leg
#C x 1 pc
Allen Wrench
#B x 8 pcs
Flat Washer

With the help of another person, carefully place the dresser (#2) on its
back on a protected surface. Align the threaded end of the center leg
(#4) with the pre-drilled hole on the bottom center of the dresser (#2) and
tighten by hand until secured.
Page 4 of 4
Turn right (clockwise) to tighten
Adjust the leveler according
to the ground level. To
lower or to raise the center
leg (#4), you need to turn
the leveler clockwise or
counterclockwise,
respectively.
I. The two mirror support brackets (#3)
are already attached behind the
dresser (#2). Position the mirror
support brackets (#3) vertically to
align with the pre-drilled holes of the
dresser (#2) AND the mirror (#1).
II. Prepare 6 bolt assemblies by
inserting the flat washer (#B) onto
the bolt (#A). (The other 2 bolt
assemblies are already attached
from the factory.)
III. Insert those bolt assemblies onto the
mirror support brackets (#3) and
secure those bolts using an Allen
wrench (#C) to lock the mirror
support brackets (#3) with the
dresser (#2) AND the mirror (#1).
IV. Tighten all bolts, including those that
were already attached from the
factory.
Back Side
Back Side
#A x 8 pcs
#B x 8 pcs
ASSEMBLY IS COMPLETED