Furniture of America CM7909F User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM7909F
Phillips Screwdriver
(not Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-03-03
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED

Page 2 of 5

Parts List
#1 x 1 pc
Headboard
#2 x 1 pc
Footboard
#3 x 2 pcs
Side Rail
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
Due to the size of this product, it is highly recommended
that the assembly should be done near the area of its
intended location. Make sure you have enough space to
move around during the assembly. ALWAYS have at least
two people to help with transporting and assembling the
product and to avoid any potential injury and/or damage.
MD
#4 x 1 kit
12-Piece Slat Kit
Page 3 of 5
Hardware List
#5 x 4 pcs
Support Leg
#A x 8 pcs
Wood Screw

Step 1
I. Insert the hooks of the side rail (#3) onto the slotted bars of the
headboard (#1). Make sure the two hooks are secured properly and
then repeat the process for the other side rail (#3) to the other side of
the headboard (#1).
II. Insert the hooks of the side rail (#3) onto the slotted bars of the
footboard (#2). Make sure the two hooks are secured properly and
then repeat the process for the other side rail (#3) to the other side of
the footboard (#2).
.
Step 2
Carefully lay out the 12-piece slat kit (#4) onto the bed rails (#3) as shown
below. Please note that there are 4 slats that have pre-drilled holes for
the support leg (#5). Install the support leg (#5) onto the slat with the pre-
drilled center hole by aligning the threaded end of the support leg (#5)
and tighten by hand until secured. Repeat the process for the remaining
3 support leg (#5).
Page 4 of 5
Enlarged
Enlarged
#4
Turn right (clockwise) to tighten

Step 3 .
Step 4 Adjusting the levelers underneath the support leg (#5): Adjust the levelers
according to the ground level. To lower or to raise each support leg (#5),
you need to turn clockwise or counterclockwise, respectively.
Leveler
Turn right (clockwise) to tighten
Page 5 of 5
Enlarged
Enlarged
Align the pre-drilled holes on the ends of the slats with the pre-
drilled holes on the side rails (#3). Insert a wood screw (#A) onto
the slat (#4) by using a Phillip screwdriver to secure that slat (#4)
to the bed rail (#3). Repeat the process for the remaining 7
locations as shown below.
ASSEMBLY IS COMPLETED
8 Locations
#A x 8 pcs