Furniture of America Canberra CM-BK607 User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM-BK607
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-06-17
Page 1 of 12
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED
Wrench (Included)
Phillips Screwdriver (Not Included)

Page 2 of 12

Before you begin, please read Page
2 for “Assembly and CareAdvice”
AND Page 12 for “Safety Warnings”.
And remember, do not tighten until
each step is completed or instructed.
MD
Page 3 of 12
OVERVIEW DIAGRAM

#2 x 1 pc
Top Left End G/Rail
Parts List
Page 4 of 12
#1 x 2 pcs
Rear Side Guardrail
#3 x 1 pc
Top Right End G/Rail #4 x 1 pc
Top Rear Side Rail
#5 x 1 pc
Top Front Side Rail #6 x 1 pc Left Guardrail Post
#7 x 1 pc
Right Guardrail Post #8 x 2 pcs
Front Side Guardrail
#9 x 1 pc
Lower Lt. End G/Rail #10 x 1 pc Lower Rt. End G/Rail
#11 x 1 pc
Center Rail #12 x 1 pc
Lower Rear Side Rail
#13 x 1 pc
Lower Front Side Rail #14 x 1 pc
Left Ladder Side
#15 x 1 pc
Right Ladder Side #16 x 3 pcs
Ladder Rung
#17 x 1 pc
Ladder Bottom Rung #18 x 13 pcs
Twin Slat
#19 x 13 pcs
Full Slat Note: Right and left are determined
by facing the FRONT of the bunk
bed in its upright position.

#D x 5 pcs
Bolt 1/4”x2”
Hardware List
#A x 16 pcs
Bolt 1/4”x3-16”
#C x 12 pcs
Bolt 1/4”x2-3/8”
#G x 14 pcs
Allen Wrench M4
Page 5 of 12
#I x 2 pcs
Center Rail Bracket
#F x 60 pcs
Screw 5/32”x13/16”
#J x 8 pcs
Wood Dowel
#B x 4 pcs
Bolt 1/4”x3-1/8”
#E x 6 pcs
Screw 1/8”x5/8”
#H x 4 pcs
Stud 3/16”x3”
#K x 16 pcs
Side Rail Bracket
#N x 2 pcs
Hex Nut
#M x 2 pcs
Bolt 1/4”x13/16”
#L x 2 pcs
Ladder Bracket
Due to the size and/or weight of this product, it
is highly recommended that the assembly
should be done near the area of its intended
location. Make sure you have enough space to
move around during the assembly. ALWAYS
have at least two people to help with
transporting and assembling the product to
avoid any potential injury and/or damage.
#O x 1 pc
Wrench

Page 6 of 12
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten

Page 7 of 12
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten

Page 8 of 12
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten

Page 9 of 12
Turn right (clockwise) to tighten

Page 10 of 12
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten