Furniture of America Walcott CM1928 User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-12-22
Page 1 of 8
DIFFICULT
ASSEMBLY RATING
CM1928
2 PERSONS RECOMMENDED
Phillips Screwdriver
(Not Included)

Page 2 of 8

Parts List Hardware List
#1 x 1 pc
Left Headboard
#2 x 1 pc
Right Headboard
#3 x 1 pc
Guardrail
#A x 8 sets
Bolt w/Nut
#B x 8 pcs
Bolt 6.3x30mm
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 2 pcs
Screw 7x100mm
MD
#D x 52 pcs
Screw 4x30mm
#4 x 1 pc
Side Rail
Page 3 of 8
#E x 8 pcs
Screw 4x20mm
#F x 4 pcs
Caster
#5 x 1 pc
Front Trundle Panel
#6 x 1 pc
Rear Trundle Panel
#7 x 2 pcs
Side Trundle Panel
#8 x 2 sets
Slat Kit (13 pcs)
#G x 2 pcs
Wood Dowel
#H x 1 pc
Allen Wrench
Note: Right and left are determined by facing
the front of the bed in upright position.

Page 4 of 8
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly.ALWAYS have at least two people to
help with transporting and assembling of the product
to avoid any potential injury and/or damage.
Overview Diagram

Page 5 of 8
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
#A x 4 sets
#C x 2 pcs
#A x 4 sets

Page 6 of 8
Turn right (clockwise) to tighten
#D x 26 pcs
#G x 2 pcs

Page 7 of 8
Turn right (clockwise) to tighten
#B x 8 pcs
#D x 26 pcs
Turn right (clockwise) to tighten

Page 8 of 8
Turn right (clockwise) to tighten
#E x 8 pcs
#F x 4 pcs
ASSEMBLY IS COMPLETED