Garden Furniture Direct Newland SRTPB User manual

1
Before you commence the assembly process we recommend that you read these instructions
thoroughly beforehand to familiarise yourself with the assembly process and to also check that you have
the correct components. If for any reason you need assistance, you can find our contact details on the
final page of these instructions.
We highly recommend that any assembly is carried out on a flat, level surface if possible and that you
use another person to assist you if necessary.
Package contents
Tools required
1 x Table top
2 x Seat panels
2 x Table leg-frames
2 x Cross braces
4 of M8 x 60mm Bolts and self locking nuts
2 of M8 x 50mm Coach screws
12 of M8 x 70mm Coach screws
Cover caps and washers
10mm socket or spanner
Newland steel picnic bench
Fuu
GGaarden
rnitu re
Direct
T: 03333 448 121
ASSEMBLY
INSTRUCTIONS
Newland steel picnic bench

Newland steel picnic bench
2
Step 1
Step 2
Ensure that you have all of the correct parts as listed
on the front page of these instructions, including any
fixings.
Lay the table top upside down on a clean, flat surface
taking care not to damage it. Now line up one of the
table A-frames centrally on the table top, ensuring
that the gap at the table edge is the same on both
sides.
Step 3
Step 4
Now, using 2 of the supplied 70mm coach screws
secure the table A-frame to the fixing batten on the
table top...
...and then repeat for the other end of the table.

Newland steel picnic bench
3
Step 5
Step 6
In preparation for attaching the cross brace (as
shown in figure 8) place a bolt and washer through
each of the two holes in the leg-frame uprights....
...and then offer up the the cross brace and loosely
secure using a washer and a locknut for each of the
two holes
Step 7
Step 8
Now attach the other end of the cross brace to the
underside of the table top using one of the 50mm
coach screws, ensuring that the hole is centrally
aligned across the middle slat of the table top.
Now tighten all of the nuts and bolts...

Newland steel picnic bench
4
Step 9
Step 10
...before repeating steps 5 to 8 for the other end of
the table.
After turning the table right side up, place each of the
two seat panels onto the frame assembly, aligning
the panels centrally across the support as shown...
Step 11
Step 12
...and using the 70mm coach screws provided attach
the seat panels to the leg-frame at both ends of the
bench.
Finally, cover any exposed coach screw/nut
heads with the cover caps provided. Your
Newland steel picnic bench is now complete.
GardenFurniture.Direct i a trading tyle of LTK Sco Limited
Regi tered in England & Wale - Regi tered No. 6282947
We hope that you found your product quick and ea y to a emble.
However, if you require any further a i tance or have any que on you can
contact u by telephone on: 03333 448 121 or vi it www.gardenfurniture.direct