8 AFTER SALES SUPPORT
MODEL: 22098-18 PRODUCT CODE: 1537 05/2018
AFTER SALES SUPPORT 9
MODEL: 22098-18 PRODUCT CODE: 1537 05/2018
USA USA
USA USA
Set-Up Instructions Take Down Instructions
WARNING
KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC.
This tent is made with fabric that meets CPAI-84 specicaons for
ame resistance. It is not re proof. The fabric will burn if le in
connuous contact with any ame source. The applicaon of any
foreign substance to the tent fabric may render the ame-resistant
properes ineecve.
STEP 3:
With each person holding a gazebo leg in hand, slide the leg hinge
(see picture) upwards until it locks in place using the pushpins near
the top of the legs. If you are having difficulty moving the leg hinge up,
make sure the gazebo frame is fully extended.
STEP 4:
Eachlegis telescopic,consisting of an upper section and alower section
that can be pulled out. Each person should place their foot on the base
of the leg and lift upwards on what is in hand. This allows the lower
section of the leg to be drawn out from the inside of the upper section.
Continue extending the lower section until the locking pins engage
the lowest height setting. All four legs should be locked in place at this
height to prevent the legs from closing back in on themselves. Once at
the lowest height, choose how much higher you would prefer the unit
to be by selecting from the remaining heights (holes) available. Use
the fastening straps found around the canopy to secure it to the bars
that make up the accordion X’s; see page 10 for part descriptions.
STEP 5:
Run Stakes (C) through designated holes found at the base of each leg.
Screw Stakes (C) clockwise while inserting them into the ground for
extra stability.
STEP 6:
Run Guide Ropes (D) through loops found at the tops of the four corners of
the canopy. Secure the Guide Ropes (D) by tying a knot at this end. Secure
the opposite ends of the Guide Ropes (D) to Stakes (C) also by tying knots.
Insert these Stakes (C) into the ground by screwing them in place as listed
in Step 5. When completed, the Guide Ropes (D) should be tightly drawn.
IMPORTANT: Do not use excessive force when closing and putting
the product away. It is advised to have four people to assist with
taking the gazebo down.
1. Untie and remove the ropes and pull the stakes from the ground.
2. Remove the stakes securing the base of the legs to the ground.
3. Push in on the pushpins found on the legs so that the upper section
collapses over the lower section of each leg. Close each leg completely
so that it is in its compact state.
4. Release the leg hinges on each leg by gently depressing the push
buttons and sliding the hinges down slightly.
5. One person should be at each leg and begin walking inwards,
gradually closing the frame at the same pace. If resistance is met, take
a step back before attempting to close the unit again. Do not force the
product closed to avoid damaging parts.
6. When the gazebo is closed and in its compact state, place the product
in its carrying bag.
Leg Hinge
