Garmin NEO User manual

NEO MOTION PLATES
Owner’s Manual

© 2022 Garmin Ltd. or its subsidiaries
All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or
improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements. Go to
www.garmin.com for current updates and supplemental information concerning the use of this product.
Garmin®, the Garmin Logo, and Tacx ® are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. These trademarks may not be used without the
express permission of Garmin.

Table of Contents
Important Safety and Product
Information...................................... 1
Device Information........................... 7
Table of Contents i

Important Safety and Product Information
WARNING
• Failure to heed the following warnings could result in death, serious injury, or property damage.
• See the Important Safety and Product Information guide in the Tacx ® NEO product box for product warnings
and other important information.
• Use the NEO Motion Plates accessory with your Tacx NEO trainer on a flat surface that is clear of any
obstructions.
• The NEO Motion Plates accessory contains magnets. Under certain circumstances, magnets may cause
interference with some internal medical devices, including pacemakers and insulin pumps. Keep devices and
mounts that contain magnets away from such medical devices.
NOTICE
• Failure to heed the following notice could result in personal or property damage, or negatively impact the
device functionality.
• The NEO Motion Plates accessory contains magnets. Under certain circumstances, magnets may cause
damage to some electronic devices, including hard drives in laptop computers. Use caution when devices
that contain magnets are near electronic devices.
Before Assembly
• The package contains 2 plates and 1 front wheel support.
• The maximum tire width is 28 mm.
• For best results, use the NEO Motion Plates with a firm mat or low pile carpet. Avoid soft and high pile carpet.
You can use a training mat that is 181 x 92 cm (71.3 x 36.2 in.) or larger.
Optional accessories are available at buy.garmin.com or from your Tacx dealer.
• Do not use the NEO Motion Plates with another motion accessory such as a rocker plate.
Important Safety and Product Information 1

Installing the NEO Motion Plates
You can use the NEO Motion Plates accessory with any Tacx NEO trainer.
1Remove the 4 feet from the Tacx NEO trainer.
2Store the feet on the NEO Motion Plates.
2 Important Safety and Product Information

3Lift the left side of the Tacx NEO trainer, and align the left plate.
Important Safety and Product Information 3

4Lift the right side of the Tacx NEO trainer, and align the right plate.
5Check the alignment of the plates on both sides.
You may need to lift and adjust each side to align the plates correctly.
NOTE: Both plates must be fully seated.
4 Important Safety and Product Information

Important Safety and Product Information 5

Positioning the Front Wheel Support
Before you can position the front wheel support, you must install the NEO Motion Plates (Installing the NEO
Motion Plates, page 2).
The front wheel support raises the front wheel of the bike for a natural cycling position and increased stability.
The maximum tire width is 28 mm.
1Use the front wheel support included with the NEO Motion Plates accessory instead of the front wheel
support included with your Tacx NEO device.
2Place the front wheel support under your front wheel.
6 Important Safety and Product Information