Gecko IN.XE-5 0602-221046 Technical manual

2- Connect the main power
Don't forget that the voltage is determined by the cable used (120 or 240 V cable)!
1- Connect all outputs & keypads
OUT1 OUT2 OUT3 OUT4
3- Select spa configuration (see chart next page)
3
At first startup the keypad display
will showõL 1 ORLL 1.
Use the Up/Down key to choose the
new low level configuration number.
Press the Program key to confirm the
selection.
21
L1 - Light connector
CO - Communication link
C - Main keypad connector
OUT5
Ground GroundL2 NL1 L1
Ground
L2
L1
For 120 V (*3 wires)
* If connected to a 3 wire system all
240 V components will not work.
The heat.wav heater is factory configured 240 V/4 kW (or 2 kW), but it can
be converted to a dedicated 120 V / 1 kW by a simply switching the cable
connection port. Option available on North American models only.
Heat.wav specification summary:
t4VQQPSUT7PS7t1SPUFDUFECZFYUFSOBMCSFBLFSOPUGVTFEt*ODPMPZ®or Titanium (optional) heater element for greater protection
against corrosion.
Connection for 240 V / heater (4 kW) Connection for 120 V / heater (1 kW)
Gro
und
N
L1
For 240 V (4 wires)
WARNING! All connections must be made by a qualified electrician in accor-
dance with the national electrical code and any state, provincial or local electrical
code in effect at the time of the installation. This product must always be connec-
ted to circuit protected by a Ground Fault Circuit Interrupter (GFCI).
2.a- Electrical wiring 2.b- Heater voltage
Note: 4o re-enter the Low level
selection menu, hold the Pump 1õkey for 30 seconds.
NoteIf the keypad does not have a
ProgramõorõFilter key, use the Lightõkey instead.
Note: For the Color keypad seriesõselect Settings menu, go into
Electrical config and choose the
appropriate Low level.
For more information, see our
website: www.geckoalliance.com
GFCI b
60 A 48 A
50 A 40 A
40 A 32 A
30 A 24 A
20 A 16 A
15 A 12 A
Press and hold the Program key
for 20 seconds until you access the
breaker setting menu.
Note: For the Color keypad seriesõselect Settings menu, go into
Electrical config and choose Input
current.
Use the Up/Down key to select
the desired value. Then press the
Program key to confirm the selection.
Note: If the keypad does not have the
Program or Filter key, use the Light
key instead.
The values displayed by the system
DPSSFTQPOEUPPGUIFNBYJNVNamperage capacity of the GFCI.
4- Select breaker current

(10 to 20 A dedicated to 120 V)
321
For more information, see our
website: www.geckoalliance.com
Quick Start Card
in.xe-5™North American version

Configuration selection chart
Standard
config. # Pump 1 Pump 2 Pump 3 Pump 4 Pump 5 Blower DIRECT 1 DIRECT 2 Circ. Pump (CP) configuration
Ozone (O3)
configuration1
Filter cycle
daily Heater
1
2SP
(OUT1)
10A-4A ?????X
(OUT5)
1A ??On filter cycle
(OUT4)
0A
2 * 2 hour
with P1 with P1
17A
2
2SP
(OUT1)
10A-4A ?????X
(OUT5)
1A ?On filter cycle
(OUT3)
2A ?2 * 6 hour
with CP with CP
17A
3
2SP
(OUT1)
10A-4A ????X
(OUT3)
5A
X
(OUT5)
1A ???2 * 2 hour
with P1 with P1
17A
4
2SP
(OUT1)
10A-4A
1SP
(OUT2)
10A ????X
(OUT5)
1A ??On filter cycle
(OUT4)
0A
2 * 2 hour
with P1 with P1
17A
5
2SP
(OUT1)
10A-4A
1SP
(OUT2)
10A ????X
(OUT5)
1A ?On filter cycle
(OUT3)
2A ?2 * 6 hour
with CP with CP
17A
6
2SP
(OUT1)
10A-4A
1SP
(OUT2)
10A ???X
(OUT3)
5A
X
(OUT5)
1A ???2 * 2 hour
with P1 with P1
17A
7
2SP
(OUT1)
10A-4A
2SP
(OUT2)
10A-4A ????X
(OUT5)
1A ??On filter cycle
(OUT4)
0A
2 * 2 hour
with P1 with P1
17A
8
2SP
(OUT1)
10A-4A
2SP
(OUT2)
10A-4A ????X
(OUT5)
1A ?On filter cycle
(OUT3)
2A ?2 * 6 hour
with CP with CP
17A
9
2SP
(OUT1)
10A-4A
2SP
(OUT2)
10A-4A ???X
(OUT3)
5A
X
(OUT5)
1A ???2 * 2 hour
with P1 with P1
17A
Software #300, rev. 002
1When the Ozonator is not controlled by a relay, it can be tied to Pump 1 Low speed or Circ. Pump.
Glossary
P1 Pump 1
CP Circulation Pump
XInstalled
1SP High speed only
2SP High and Low speed
(OUT, AMP, Relay, Tab) Output connector
10A, 10A-4A Output current: 1 speed or High - Low speed
For complete TechBook or more information, see our website: www.geckoalliance.com
9919-101318-B Rev. 11-2015 www.geckoalliance.com
© Groupe Gecko Alliance Inc., 2015
All trademarks or registered trademarks are the property of their respective owners.