General Pump BIKLEENER 2100473 User manual

The
Original
• Recommended for units with
pressures of 2000 to 3500 PSI
• uick connect to pressure washer
wand
• 2 (1.5x60) nozzles for a wide
cleaning path
• Upright operation saves back
strain and fatigue
• Consistent 10 - 12" even cleaning
path
• Cleaned area is easy to see and
review
• Disconnects in a snap for easy
storage
• COMMERCIAL GRADE - FIELD
TESTED FOR 3 YEARS
WARNING: Using a pressure
washer involves water under
intense pressure. ever point
the water stream towards
anyone and do not get any
body parts near stream as it
could cause serious
injury
OPERATOR’S
MANUAL
®
Revision C
102018
Model #2100473

1. CONNECTING TO PRESSURE WASHER WAND
Utilizing the quick connect fitting on the hand wand of the unit, connect directly onto the top of the
BIKLEE ER male fitting.
2. SETTING THE HEIGHT ADJUSTERS
Pushing the metal tab, release the bar so that settings are possible. The lower the setting, the closer
the unit will be to the ground, increasing the velocity of water and increasing the cleaning power. By
raising, it decreases the velocity thereby creating a “gentler” stream for painted surfaces.
3. UTILIZING THE BIKLEENER TO ITS MAXIMUM CLEANING POWER
The unit is designed to be best used at approximately a 30 degree angle to push the dirt and grime
away from the user. There are two methods found effective. The first is using the unit in a “vacuum
cleaning” motion, and the other is to roll the unit in a straight line in a slow and deliberate manner.
Each method has been found to be effective.
4. MISCELLANEOUS USES
Cleaning street curbs, decks, docks, painted porches or even 90 degree curbs can be cleaned
utilizing the BIIKLEE ER. Simply adjust settings as desired.
OTHER SAFETY PRECAUTIONS
1. ALWAYS have unit turned off when adjusting unit in any manner.
2. NEVER attemp to adjust nozzle spray patterns when unit is engaged.
3. After completing the cleaning job, and pressure washer unit is turned off, pull trigger in your
hand wand in order to release pressure BEFORE disconnecting the BIKLEE ER®.
5. MAINTENANCE
It is recommended user washes debris from unit thoroughly after each use.
Thoroughly rinse and lubricate fittings after use.
Revision C
102018
Page 2 of 4

8
7
2
1
4
9
3
5
11
6
10
12
ITEM
NO.
PART
NO. DESCRIPTION TY.
1 2103304 PAWL ASSY., LEFT 1
2 2700018 WHEEL, 6" 2
3 2530094 CO ECTOR, MALE, 1/4 1
4 2103302 FRAME ASSY. 1
5 2203412 FLAT WASHER, M12 1
6 2103303 PAWL ASSY., RIGHT 1
7 2200008 WASHER, FLAT, M10 2
8 2200033 UT, M10 2
9 2520147 MA IFOLD 1
10 D960015M OZZLE, 60° X 1.5 2
11 2400162 LABEL, WATER BROOM 1
12 2800004 U CLOGGER, OZZLE 1
2100510 OZZLE REPAIR KIT (2) D960015M,
2100511 FLAPS & RIVETS REPAIR KIT
PARTS LIST
Revision C
102018
BIKLEENER®NOZZLE CHART
Step 1: Find your pressure washer PSI rating on the table above.
Step 2: Find your GPM in the column of your PSI.
ozzles can be purchased at most Pressure Wash dealers or aftermarket dealers
FOR MORE INFORMATION, OR TO VIEW AN INSTRUCTIONAL VIDEO,
VISIT www.getkleener.com
Nozzle
Size
PSI (Pounds Per Square Inch)
1750 2000 2250 2500 2750 3000 3250 3500
2.5 1.32 1.41 1.50 1.98 2.07 2.17 2.25 2.34
3 1.65 1.77 1.88 2.37 2.49 2.60 2.70 2.81
3.5 1.98 2.12 2.25 2.77 2.90 3.03 3.15 3.27
Page 3 of 4

Manufactured for GETKLEENER®by
General Pump
1174 orthland Drive • Mendota Heights, M 55120
Revision C
102018
DIMENSIONAL DRAWINGS
OTE: Dimensions in mm,
[ } in inches.