Image Setting
Quality
Frame Rate
H / M / L
25 fps / 12 fps / 4 fps
Playback
Select the file you want to display.
Display Mode:
Left / REW
Right / FF
Play / Pause
Press (UP & DOWN) to select item.
Press (ENTER) to confirm.
Press (ESC) to return to previous menu.
Press (UP & DOWN) to select item.
Press (ENTER) to confirm.
Press (ESC) to return to previous menu.
Press (UP & DOWN) to select the file.
Press (ENTER) to confirm,then press to play.
Press (ESC) to return to previous menu.
Press (Delete) to delete the file.
Press (UP & DOWN) to select item.
Press (REC) to start recording.
Press (STOP) to stop recording.
Press (ESC) to return to previous menu.
Press (UP & DOWN) to select item.
Press (ENTER) to confirm.
Press (ESC) to return to previous menu.
REC. Setting
Scheduled Time
Overwrite
Section
Motion Detection
YES/NO
15min / 30min / 1hr
Mask Area
Sensitivity
H / M / L
DD/MM/YYYY 00:00
DD/MM/YYYY 00:00
Press to select area.
Press (ENTER) to confirm or cancel.
Press to adjust number.
Press (ENTER) to confirm.
Press to select.
REC. Mode
Motion Detection
Scheduled
Manual
Go to “Motion Detection” Setting
to set up
Go to “Scheduled Time” Setting
to set up
System Setting
Language
Time
Format
Card Info.
English
German
Spanish
DD/MM/YYYY 00:00
YES/NO
Total Size:
Usage Size (%):
Remain Size (%):
Press to adjust number.
Press (ENTER) to confirm.
Press to select.
Press to delete the file on the recording list.
Press to return to previous menu and quick playback.
Press to move left in the “mask area” and
4 levels of fast backward playback.
Press to move right in the “mask area” and
4 levels of fast forward playback .
Press to play / pause the playback.
Press to select item and to increase or decrease
the volume level during the playback.
Press to comfirm and start recording.
Press to enter and exit the menu.
Press to stop recording.
If under "Scheduled Time Mode" press
"MENU/Pre" or "ESC/MODE" to stop recording.
Battery
PS.Make sure batteries are installed before using the Remote Control.
Installation
Remote Control
Operation Manual
1
2
3
4
1.SD CARD
2.DVR BOARD
3.LENS BOARD
4.LED
Step 1. Install the camera and ensure each plug
is properly connected.
Step 2. Insert the SD card and go to the system
settingsto format for first time.
Step 3. Use the remote cotroller and press
“MENU” icon to set up the system.