Genie Aladdin Connect User manual

Installation Manual
Download the app here

www.GenieCompany.com
Table of Contents
Important Safety Information........................................................................1-3
Included Parts..........................................................................................................4
Downloading the App..........................................................................................5
Initial Programming ..........................................................................................6-7
Installation Variables ...................................................................................... 8-11
Installation & Wiring.....................................................................................12-13
Final Programming and Testing..................................................................... 14
Adding Additional Doors.................................................................................. 15
Terms of Use....................................................................................................16-19
Troubleshooting .................................................................................................. 20
Warranty ................................................................................................................. 21

1
1-866-599-4995
WARNING
TO REDUCE THE RISK OF SEVERE INJURY OR
DEATH, READ AND FOLLOW ALL INSTRUCTIONS.
1. NEVER let children operate or play with the door controls.
2. Keep remote away from children.
3. Locate the wall control button: A) Within sight of door. B)
At a minimum height of 5 feet, so small children cannot
reach it.
4. Install the entrapment WARNING label next to the wall
button or console, in a prominent location.
5. NO ONE SHOULD CROSS THE PATH OF THE MOVING
DOOR.
6. NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR.
7. The Aladdin Connect™ operating system is designed
for unattended operation. The door could move
unexpectedly.
8. DO NOT install Aladdin Connect™ on garage door
openers manufactured prior to 1993 without photocell
non-contact safety sensors.
9. DO NOT install on one-piece doors.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF SEVERE INJURY OR
DEATH, READ AND FOLLOW ALL INSTRUCTIONS.
1. NEVER let children operate or play with the door controls.
2. Keep remote away from children.
3. Locate the wall control button: A) Within sight of door. B)
At a minimum height of 5 feet, so small children cannot
reach it.
4. Install the entrapment WARNING label next to the wall
button or console, in a prominent location.
5. NO ONE SHOULD CROSS THE PATH OF THE MOVING
DOOR.
6. NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR.
7. The Aladdin Connect™ operating system is designed
for unattended operation. The door could move
unexpectedly.
8. DO NOT install Aladdin Connect™ on garage door
openers manufactured prior to 1993 without photocell
non-contact safety sensors.
9. DO NOT install on one-piece doors.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
translate to French

2
www.GenieCompany.com
DCM
(Door Control Module) DPS
(Door Position Sensor)
Hardware Bag PowerPack
Wire Spool
Insulated
Staple x30
Included Parts.
DPS
Mounting
Bracket
DPS Mounting
Adheasive
Strip
DPS Mounting Screws
DCM Mounting Screws
DCM Mounting Screw
Anchors

3
1-866-599-4995
www.GenieCompany/Aladdin.com
Visit your app store to download QR
code readers.
Getting Started.
This should be some text to introduce
the homeowner to this product.
Something from marketing perhaps?
FCC/IC Statement:
This device complies with FCC Part 15 rules
and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference,
and
(2) This device must accept any interference,
including interference that may cause
undesired operation of this device.
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils
radio exempts de license. L’exploitation est
autorisée aux deux conditions suivantes:
(1) I’appareil no doit pas produire de
brouillage, et
(2) l’utilisateur de l’appareil doit acceptor
tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en
compromettre le fonctionnement.

4
www.GenieCompany.com
In the Home close to WiFi Router:
Prepare Aladdin Connect™ by rst scanning the QR code™ on this
instruction or on the back of the DCM (Door Control Module) or
visit www.GenieCompany.com to start the setup of the Aladdin
Connect™ device.
1. Remove Mounting Bracket from back of DCM. (a)
2. Plug Aladdin Connect™ DCM into outlet with Power Pack. (b)
3. Download the app.
4. Create an account.
5. Begin programming.
Plug Aladdin Connect™ into wall outlet with power-pack.(c)
Follow the on-screen menus to set and program system prior to
wiring in the garage.
1. Pair Wi-Fi router with Aladdin Connect™ (DCM)
2. Pair Door Position Sensor (DPS) with Aladdin Connect™
Once setup is complete, move system to the garage.
WI-FI Signal Indicator
GOOD -- WEAK -- POOR
DPS Signal
Blue LEDs
Power Indicator
a b
c

5
1-866-599-4995
In the Garage:
Plug powerpack into wall outlet and DCM.
The RED power indicator LED should illuminate.
The WI-FI signal indicator LED should illuminate signaling that the
WI-FI signal is still in tact.
• A GREEN LED indicates a good WI-FI signal.
• AYELLOW LED, indicates a weak signal. Move Aladdin
Connect™ to a position that better suits the Wi-Fi signal from
the router.
• A RED LED, indicates a poor Wi-Fi signal. Move Aladdin
Connect™ to a position that better suits the Wi-Fi signal from
the router or call 1-800-599-4995.
The DPS door sensor BLUE LED(s) on the DCM will also illuminate.
(One for each door programmed).
These factors must be determined prior to mounting Aladdin
Connect™ (DCM) to the wall or ceiling.
1. Optimal Wi-Fi signal strength.
2. Desired and/or garage door opener(s) wall control location.
3. Access to 110VAC outlet within 5 feet.
Once an optimal signal and location is obtained, wire the DCM to
the garage door opener(s).
WI-FI Signal Indicator
GOOD -- WEAK -- POOR
DPS Signal
Blue LEDs
Power Indicator

6
www.GenieCompany.com
Typical
Installation
WiFi
Installed directly
to the garage
door opener next
to wall control.
Determine Location for
Wiring

7
1-866-599-4995
Installed directly to the wall control.

8
www.GenieCompany.com
Installed replacing the wall control