Globe Scientific GTR-ID User manual

GTR-ID
Industrial Tube Rotator
Quick Start Guide
Continued . . .
What’s in the box:
• Quick Start Guide
• Tube Rotator
• 50mL Tube Holder Disk
• Power Cables (3 each)
• Set of (4 each) Screws, Flat
Washers and Lock Washers
• Allen Wrench
• Extra Fuse
INITIAL SETUP
The 50ml tube holder disk comes standard with the GTR-ID,
but it must be installed. The instructions below show how to
install any available tube disk holder accessory:
Secure the tube holder disk accessory with the four screws, lock
washers and washers (installed in that order) using the included
Allen wrench.
12

®
Customer Service, Sales and Technical Support:
Phone: [phone] • 1 [phone]
Fax: 1(201)599-1406•E-mail:mail@globescientic.com
©2019GlobeScienticInc.Allrightsreserved.TheGlobeScienticlogoisaregisteredtrademarkofGlobeScienticInc.GTR-IDGuide19107
For the full User Manual, please visit www.globescientic.com
GTR-ID
Industrial Tube Rotator
Quick Start Guide
Error Display
Set
Display Description
Set Shownwhensettingatargetvalue.
Err Shown when an error occurs.
Display Area: When Set is shown, the display shows
thesetvalue;When Set disappears, the
displayareashowstherunningvalue.
CONTROL PANEL / OPERATION
Speed / Timer Control Knob
Rotate to set speed and time.
Push to start/stop.
Power / Overload Indicator
Green LED indicates
power on. Steady red
LEDindicatesoverload
protection is enabled.
Flashing red LED indicates
overloadandrotator
operation is stopped.
Speed / Timer Indicator
Green LED indicates the
LCD screen currently
displays speed. Red LED
indicates the LCD screen
currently displays time.
LCD Display
Displays the working state,
allsetvalues,andanyerrors.
(See table below.)
Mode Switch Button
Press to switch between
speed and time.
On / Off Switch
Toggles power to the
unit on and off.