Goldair GEOH400 User manual

For models: GEOH400 & GEOH410
2400W OUTDOOR INFRARED HEATER
OPERATING INSTRUCTIONS

Thank you for choosing GOLDAIR. Your GOLDAIR Outdoor Infrared Heater has
been designed and manufactured to high standards of engineering. With
proper use and care, as described in this leaflet, you can expect years of service.
Please read these instructions carefully.
GENERAL CARE AND SAFETY GUIDE
Please read all instructions carefully before using your bathroom heater and
keep them for future reference.
•Use only the voltage specified on the rating plate of the appliance.
•Do not cover or restrict airflow as the appliance may overheat and become a
fire risk.
•Do not cover grill, block entry or exhaust of airflow by placing these areas of
the appliance against any surface.
•Do not mount appliance close to any heat source.
•Do not operate in areas where petrol, paint or other flammable liquids are used
or stored.
•Do not use the appliance to dry clothes.
•Keep all objects at least 1 metre from the front and sides of the appliance.
•Do not insert or allow foreign objects to enter any entry or exhaust opening, as
this may cause an electric shock, fire or damage to the appliance.
•Do not immerse in liquid or allow liquid to run into the interior of the appliance,
as this could create an electrical shock hazard.
•Do not operate with a damaged cord or plug, after the appliance malfunctions,
has been dropped or damaged in any manner.
•If the power cord is damaged, it must be replaced by a qualified electrician in
order to avoid a hazard.
•Do not operate the appliance with wet hands.
•Use this appliance only as described in this manual.Any other use is not
recommended by the manufacturer may cause fire, electric shock or injury.
•Do not connect the appliance to the mains voltage until completely assembled.
•This appliance is intended for household use only and not for commercial or
industrial use.
•This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience or knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
•Young children should be supervised to ensure they do not play with the
appliance.
•The appliance should not be located in front of a socket outlet.
•Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.

INSTALLATION
For additional protection the installation of a residual current device (RCD) is advisable.
1.Remove all packaging material and check the appliance, supply cord and the plug for signs of
damage.
2.Also check the mounting bracket and all mounting hardware (plates, screws, etc.)). Ensure they
are not damaged.
3.The mounting distances below must be followed during installation.
The distance between the bottom edge of the appliance and the floor must be at least 1.8M.
There must be a distance of at least 0.5M between the appliance and any soffit or eve.
There must be a clearance of at least 1.5 M on all sides from walls and other objects. See figure 3.
Recommended angle for mounting the heater is 45°. See figure 4.
The heater can also be swung from left to right. Maximum 90°
4.The mounting location of the heater should not be in a location subject to high winds.
5.Fix the mounting bracket on the wall first. Ensure that the bracket is mounted and fixed securely
into a wall/eve.Adjust the angle of the heater to its desired angle. Check regularly to ensure the
screws are securely fastened, as over time they may become loose.
6.Plug the heater into a power outlet and turn the heater on. Observe the heater for 10-15 minutes
to ensure the heater operates trouble free.
INSTALLATION INSTRUCTIONS

CLEANING
•Before cleaning, remove the plug from the power outlet and wait until the appliance has cooled
down
•Wipe the appliance with a clean and lint-free cloth or soft brush.
•Never use abrasive cleaners, scrubbing brushes and chemical cleaners for cleaning
•To protect against an electrical shock, do not immerse the cord, plug, or any part of the appliance
in water or other liquid.
Do not attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will
void the warranty. Contact a qualified electrical service technician to service the heater.
TECHNICAL SPECIFICATIONS
•Power 2300-2400W
•Voltage 230-240V ~ 50Hz
•IP Rating IP65
INSTALLATION INSTRUCTIONS
SUPPORTAND TECHNICALADVICE
North Shore City, Auckland, New Zealand
Monday –Friday 8am-5pm
Phone: [phone]
Website: www.goldair.co.nz

Your Goldair product has been inspected and tested and is guaranteed subject to the
following for a period to one year from the date of purchase against defects in
workmanship and materials. During this period, such defects will be rectified by
repair or replacement of the product purchased. Your product contains no user
serviceable components and this warranty becomes invalid if in our opinion the
product has been misused, abused, incorrectly installed, tampered with, connected
to an electrical supply not corresponding with the name plate specification, or
subjected to power surges. The warranty does not include any labour or other
associated expense that may be involved in removal or installation of the product.
Normal wear and tear is expressly excluded.
If your Goldair product fails to operate satisfactorily, please return it to the retailer
from whom it was purchased. To obtain a repair or replacement product under this
warranty, you will need to produce satisfactory evidence of date of purchase. The
completed warranty and purchase receipt must be presented with the product. The
warranty should be filled out at the time of purchase. It is in your interest to make
sure this is done.
If the product is to be replaced (cannot be repaired) then that replacement will be of
the same or similar product or accessory excluding packaging, instruction card etc.
Where a replacement product is supplied, this shall be guaranteed for the balance of
the original warranty period.
Any model that is no longer available will be replaced by a model of a value and with
such features as we consider appropriate in the circumstances. Goldair Ltd is not
responsible for freight forwarding charges, losses or damage in transit.
If service is required after the warranty period has expired, the product should be
returned to a qualified electrical technician. Service outside of the warranty period
will be at your cost.
Consumers GuaranteeAct (1993).
In accordance with the above act consumers are advised that: The manufacturer
does not undertake that repair facilities and parts are necessarily available for this
product.
If any of the provisions of the foregoing are contrary to any relevant legislation, then
that provision shall be deemed to be excluded from the warranty and the rest of the
provisions will continue to apply.
ONE YEAR WARRANTY
IMPORTANT: PLEASE RETAIN THIS WARRANTY CARD
NAME:
ADDRESS:
PURCHASED FROM:
SUBURB:
DATE OF PURCHASE:
NAME OF PRODUCT:
MODEL No: