Goldair GMH325 User manual

OperatingInstructions
Model: GMH325
2400W Electronic Micathermic Heater

This page is intentionally left blank

CAUTION: In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is regularly
switchedonandoff by the utility.
•This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge, unless they are supervised or have been given instruction
concerningthe use of the appliance byaperson responsible fortheirsafety.
•Children should be supervised to ensure that they do not play with the
appliance.
•If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent orsimilarlyqualified persons inorderto avoida hazard.
WARNING: You must not cover this appliance. Covering this appliance
presents fire risk and will activate the safety fuse; permanently disabling the
unit.
WARNING: Do not use this appliance in small rooms when they are
occupied by persons not capable of leaving the room on their own, unless
constantsupervision isprovided.
WARNING: To reduce the risk of fire, keep textiles, curtains, or any
flammable material aminimumdistanceof 1 metre fromthe air outlet.
General Care and Safety Guide
•Use only the voltage specified on the rating label of the appliance.
•Keep all objects at least 1 metre from the front, sides and rear of the
appliance.
•This appliance is intended for household use only and not for commercial or
industrial use.
•Indoor use only.
•Use this appliance only as described in this manual. Any other use is not
recommended by the manufacturer and may cause fire, electric shock or
injury.
•Do not use the appliance if it has been dropped or damaged.
•The common cause of overheating is deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly by unplugging the appliance and
vacuum cleaning the air vents and grills.
YOUR SAFETY IS IMPORTANT TO US. PLEASE ENSURE YOU TAKE NOTE OF THE
INSTRUCTIONS AND WARNINGS OUTLINED IN THIS MANUAL.

•Never use the appliance to dry clothes.
•Always unplug appliance when not in use.
•When the appliance has been unpacked, check it for transport damage and
ensure all parts have been delivered. If parts are missing or the appliance has
been damaged, contact the Customer Services Team.
•Do not use if there are visible signs of damage to the appliance.
•Do not connect the appliance to mains supply until completely assembled and
adjusted.
•Ensure hands are dry before handling the plug or main unit.
•Ensure appliance is on a flat, stable, heat-resistant surface.
•Do not operate with cord set coiled up as a heat build up is likely, which could
be sufficient to become a hazard.
•Carry out regular checks of the supply cord to ensure no damage is evident
•Do not operate this appliance with a damaged cord, plug or after the appliance
malfunctions or has been dropped or damaged in any manner. Take to a
qualified electricalperson for examination, electrical service or repair.
•Do not twist, kink or wrap the cord around the appliance, as this may cause the
insulation to weaken and split. Always ensure that all cord has been removed
from any cord storage area and is unrolled before use.
•It is recommended that this appliance is plugged directly into the wall socket.
Power boards are not rated to supply power to high wattage appliances.
•A correctly specified, undamaged extension cord may be used with this
appliance provided it is used in a safe manner.
•Do not remove plug from power socket until the appliance has been switched
off.
•Do not remove plug from power socket by pulling cord; always grip plug.
•Do not place cord under carpet or cover with rugs or furniture. Arrange the cord
so it cannot be tripped over.
•Don’t place appliance on bedding or on thick & long carpet where the openings
may get blocked.
•Switch off and use handle provided when moving
•Do not place appliance close to radiant heat source.
•Do not insert or allow foreign objects to enter any ventilation or exhaust
opening, as this may cause an electric shock, fire or damage to the appliance.
•Do not sit on the appliance.
•Do not use abrasive cleaning products on this appliance. Clean with a damp
cloth (not wet) rinsed in hot soapy water only. Always remove plug from the
mains supply before cleaning.
•Do not operate in areas where petrol, paint or other flammable liquids are used
or stored.
•Do not use this appliance in the immediate surrounds of a bath, a shower, or a
swimming pool or other liquids.
General Care and Safety Guide

WARNING!
DANGER IF SWALLOWED
Keep batteries out of reach of
children. Swallowing may lead to
serious injury or death in as little
as 2 hours due to internal burns.
If swallowed, go straight to a
hospital emergency room.
Dispose of used batteries
immediately.
General Care and Safety Guide
The remote control supplied with thisappliance uses aCR2025 coin type battery.
DANGER IF SWALLOWED
Keep batteries out of reach of children. Swallowing may lead to serious injury or
deathin as little as 2hoursdue to internal burns.
If swallowed, go straight toa hospital emergency room.
Dispose of used batteriesimmediately.
•Do not locate the heater immediately below a socket-outlet.
•The appliance must not be immersed in any liquids.
•There are no user serviceable parts installed in the unit.
•Do not place the unit in wardrobes or other enclosed spaces as this may cause
fire hazards.
•This unit is not supposed to be used in or around locations where foodstuffs,
works of art or delicate articles of science, etc. are stored.
•If your appliance does not work, or is not working properly, contact the place of
purchase or the Customer Services Team.

ASSEMBLY INSTRUCTIONS
1. Carefully turn the Main Body upside-down on a scratch-free and stable surface.
Be careful to prevent damage to the cosmetic finish or your floor surfacing.
2. Attached the feet to the bottom of the heater with the more rounded end of the
foot to the front of the heater.
3. Turn the heater the right way up.
Foot x 2
Main Body x 1
Remote x 1
Before using this appliance, it must have the feet fitted.
WARNING:Heatermustnot be used withoutthe feet
This appliance has been supplied with ‘1 way screws’ for permanent
installation of the feet. Thisisasafetyrequirementforthe NewZealand and
Australian market.
Assembly Instructions

Operating Your Heater
Always choose a safe location for the heater, keeping in mind the safety precautions
outlined. Ensure all packaging has been removed from the unit before use. Please
follow the below instructions.
WARNING:In orderto avoid overheating orfire, do notcoverthe heater.
WARNING: Keep all objects at least 1 metre from the front, sides and rear
of the appliance.
WARNING: Do not use this heater with a programmer, separate timer,
remote-control system or any other device that switches the heater on
automatically, since a fire risk exists if the heater is covered or positioned
incorrectly.
WARNING:Never leave this heater unattended when inuse.
Ensure heaterison a flat, stable, heat-resistant surface.
Once the heater is in a safe operating position and all switches are in the off
position, insert the power plug into the mains outletand switch on.
CAUTION: Ensure the power cord is not tight because if pulled it may
partially pull the plug from the socket. A partially inserted plug will overheat
the plugand socketandcouldresult infire.
Note: When the appliance is turned on for the first time, it may release a
slight odour or smoke. This odour or smoke is a normal occurrence caused by
the initial heatingof the heating elements and should not occuragain.

Operating Your Heater
HEAT CONTROL SWITCH
•Check that the heat control switch at the back of the heater is
set to Off position before plugging the heater in and turning on
the mains supply.
•Turn the Power Switch at the back of the heater to the “I”
position. The heater will go into ‘Standby’ setting. @ ‘Dashes”
will bedisplayed on the control panel screen.
CONTROL PANEL
•Press the Power button on the control panel to turn the heater
on, the unit will begin on High Heat.
•The LED will display the current room temperature and the ‘H’
(high) power setting and the ‘H’ indicator will belit.
•Press the ‘MODE’ button and the heater will reduce to operate
in‘M’ (medium) heat setting.
•Press the “MODE’ button again and the heater will operate in ‘L”
(low) heat setting.
•The corresponding indicator light will display on the control
panel screen.
THERMOSTAT
Press the ‘+’ or ‘-’buttons to adjust the temperature to your desired
setting (from 15-45°C). Once you have set the desired temperature,
the LED will display the room temperature again and will rise as the
room temperature increases.
To find your preferred heat setting, set the thermostat to the
maximum setting. When the room reaches a comfortable
temperature for you, look atthe temperature reading on the heater
and then set the heater to this temperature. The heater will now
cycleon and off to maintain the set temperature.
NOTE: the temperature is read from a thermostat in the heater, for
a more accurate reading, position a separate thermometer in
another part of the room.
NOTE: This heater has a safety tip-over switch. If the heater is
knocked over or tipped more than 15 degrees it will shut off and
when put back into the upright position it will have reverted to
Standby setting.

Operating Your Heater
TIMER
Press the button then use the ‘+’ or ‘-’buttons to adjust the length of time
from 1–24 hours that you would like the heater to run for before turning off.
Each press of the ‘+’ or ‘-’button will adjust the length of time by 1 hour
increments.
To turn off the Timer function, set the Timer back to ‘0’hours or simply turn the
unitoff.
REMOTE CONTROL
The remote will operate all of the controlsthe same as the control panel.
The remote control receiverisonthe side of the heaterunderthe control panel.
Thisremote requiresaCR2025 battery.

SUPPORT AND TECHNICAL ADVICE
Goldair –New Zealand
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[e-mail]
Goldair –Australia
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[e-mail]
Operating Your Heater
TECHNICAL SPECIFICATION
Model No: GMH325
Supply: 230-240VAC 50Hz
Wattage: 2100-2400W
SAFETY DEVICES
This appliancehas three protection devices:
•Tilt switch - this will automatically turn the appliance off if the appliance is not in
the correct operatingposition.
•Resettable thermal link - this will automatically disconnect the power to the
appliance at a pre-set overheat temperature. After cooling down it will reset and
power on again. If this occurs, investigate what is causing the appliance to
overheat.
•Thermal fuse - this disconnects the appliance permanently in case of overheating.
(It is non resettable).
CAUTION: The appliance generates heat during use. Precautions must be
takento prevent the risk of burns, scalds, fires orotherdamage topersons.
CARE AND CLEANING
The heater requires regular cleaning to ensure trouble free operation:
•Unplug the heater from the mains supply before cleaning.
•Ensure that the heater has been allowed to cool down completely before cleaning.
•The common cause of overheating is deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly by unplugging the appliance and
vacuum cleaning the air vents and grills.
•Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and
dirt.
•Never usesolutions such as petrol,thinners or polishing agents.
•Ensure the heater is dry before pluggingback into the mains supply.
•Do not attempt to dismantlethe appliance.
•There are no user serviceable parts. For service or repair, contact an authorised
electrical servicetechnician.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase.

Thank you for purchasing this Goldair product. Your p roduct is warranted against f aults and manufactu re when used in normal
domestic use for a period of two years. In non-domestic use Goldair limits the voluntary warranty to three months.
Goldair undertake to repair or replac e this product at no ch arge if found to be def ective due to a manufacturing f ault during th e
warranty period.
This warranty excludes damage caused by misuse, neglect , shipping accident, incorrect installation, or work carried out by anyone
other than a qualified electrical service technician.
PLEASE KEEP YOUR RECEIPT AS THIS WILL HELP VERIFY YOUR WARRANTY.
The b enefits given to you by this warranty are in addition to oth er rights and remedies available to you under law in relation to the
goods or services to which this warranty relates.
In Australia, our goods come with guarantees that cannot be excluded under th e Australian Consumer L aw. You are entitled to a
replac ement or refund for a major failure and compensation for any other reasonably foreseeable loss or d amage. You are also
entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a
major failure.
In New Zealand this warranty is additional to the conditions and guarantees of the Consumers Guarantee Act (1993).
Two Year Warranty
Goldair Two Year Warranty (IMPORTANT: Please complete and retain this warranty card)
Name
Address
Place Of Purchase Date Of Purchase
Name Of Product Model Number
Attach a copy of the purchase receipt to this warranty card
Due to continual design improvements, the product illustrated in this User Manual may differ slightly from the actual product .
Goldair –New Zealand
CDB Goldair
PO Box 100-707
N.S.M.C
Auckland
Phone [phone]
Phone [phone]
www.goldair.co.nz
Goldair –Australia
CDB Goldair Australia Pty
PO Box 574
South Morang
Victoria, 3752
Phone [phone]
Phone 1300 GOLDAIR (1300 465 324)
www.goldair.com.au

New Zealand
PO Box 100707,
North Shore Mail Centre,
Auckland, 0745
www.goldair.co.nz
Australia
PO Box 574,
South Morang,
Victoria, 3752
www.goldair.com.au