Graco 24A431 User manual

GENUINE GRACO PARTS AND ACCESSORIES
24A431 Wide Pattern Kit
For PRO Xs Electrostatic Air Spray Guns 406721B
Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
406721 Rev. B 12/2008
Copyright 2008, Graco Inc. is registered to ISO 9001
Install Wide Pattern Fitting
1. Locate the three hex socket screws (11),
that connect the gray barrel (16) to the
black handle (17), see FIG. 1. Loosen all
three screws using a 4mm hex tool and
leave the screws retained.
2. Separate the gray barrel (16) from the
black handle (17), see Fig. 2.
Important Safety Instructions
Read all warnings and instructions in manual
309291, 309292, or 312900. Save those
instructions.
Fig. 1. Loosen three hex socket screws
Fig. 2. Barrel and handle separated
All manuals and user guides at all-guides.com
all-guides.com

3. Locate the ¼” air passage adjacent to the air
adjustment knob on the left-hand side of the gun
body, see Fig. 3.
FIG. 3. Left-hand side air passage
4. Insert the supplied wide pattern fitting in the ¼”
air passage, see Fig. 4. The fitting will be a slip fit
within the ¼” air passage.
FIG. 4. Wide pattern fitting inserted into the ¼” black
gun body air passage
5. Reassemble the gray barrel (16) to the black gun
body (17) and tighten the three screws (11).
6. Check gun resistance as instructed in your spray
gun instruction manual.
Remove Wide Pattern Fitting
1. Remove the wide pattern fitting by repeating
installation steps 1 – 2.
2. Use a pick or sharp metal object to slide the fit-
ting out.
All manuals and user guides at all-guides.com