Graco 24J149 User manual

3A1653A
ENG
Instructions
Bottom Feed Fittings Kit for RoadLazer™
RoadPak™Line Striping System
- For use with waterborne paints -
Model 24J149
75 psi (0.5 MPa, 5 bar) Maximum Working Pressure
Important Safety Instructions
For complete warnings and safety instructions see RoadLazer™
RoadPak™Line Striper System manual. Save these instructions.
ti17198a

Installation
1. Drill a 3 in. hole in the bottom of the tank that the
bottom feed fittings are being installed into.
2. Assemble gasket (4) to fitting (5) and insert through
3 in. hole as shown below.
3. Tighten nut (3) to securely fasten the fittings to the
tank. Screw in barbed fitting (2) to (5). NOTE: Be
sure to install fitting (2) aimed in desired direction.
4. Assemble 1.5 in. ID hose to barbed fitting and
secure with a clamp.
Parts
ti17210a
ti17211a
32
5
Ref. Part Description Qty.
1 125141 FITTING, thru-wall blkhd, 1-1/2 in. 1
2 125142 FITTING, 90 elbow, 1-1/2 in. x barb 1
3 125145 NUT, 1-1/2 in. poly tank flange 1
4 125143 GASKET, 3 in., fkm 1
5 125144 BODY, 1-1/2 in. poly tank flange 1
1
2
ti17199a
3
4
5
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
Original instructions. This manual contains English. MM 3A1653
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441
Copyright 2010, Graco Inc. is registered to ISO 9001
www.graco.com
Revision A - 04/2011