Graco 256212 User manual

312933A
Instructions
Lacquer Conversion Kit 256212
Important Safety Instructions
Read all warnings and instructions in this manual and in the
sprayer operation manual. Save these instructions.
ti11870a

2312933A
Lacquer Conversion Kit 256212
Ref. Part No. Description Qty.
1 117559 O-RING, CV-75, size 020 1
2 111507 O-RING, CV-75, size 013 1
3 111316 O-RING, CV-75, size 012 1
4 15D370 O-RING, CV-75, size 022 1
5 15D371 O-RING, CV-75, size 015 1
6 15D252 O-RING, CV-90, size 008 1
7 119400 SEALANT, pipe, sst 1
8 15D883 TUBE, suction 1
2
2
ti11872a
1
2
2
8
Apply light coat of lithium-based grease
Do not use hook storage with new suction
tube as it is not flexible enough to allow
for bending. Damage will occur.
1
2
6
5
3
4
B
A
C
D
1
ti11871a

312933A 3
Instructions
1. To relieve pressure:
a. Turn power switch to OFF.
b. Unplug sprayer.
c. Turn knob (A) down to PRIME/DRAIN.
d. Hold metal part of gun firmly to a grounded
metal pail. Pull gun trigger to relieve pressure.
2. Turn knob (A) up to SPRAY position.
3. Remove pin (B) with pin punch and hammer.
4. Remove knob (A) and base (C).
5. Remove valve stem (D) from manifold. Be sure gas-
ket (X) and seat (Z) do not stay in manifold.
6. Replace brown o-ring (6) on end of valve stem.
Apply sealant (7) to valve threads. Install valve stem
in pump manifold. Torque to 185 in-lb (21 N•m).
7. Install base (C) on valve, aligning pin (E) on base
(C) with hole (F) on manifold.
8. Rotate valve stem with a pin punch until hole is per-
pendicular.
9. Install knob (A) over base (C).
10. Place knob in SPRAY position.
11. Insert end of pin punch through hole in knob (A), to
make sure knob and valve stem are aligned.
12. Install pin (B) through hole in knob (A). Tap pin
through knob with hammer. End of pin will be flush
with top of hole in knob when correctly installed.
B
A
A
B
C
D
X
Z
C
E
F
A

All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
This manual contains English. MM 312933
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441
Copyright 2008, Graco Inc. is registered to I.S. EN ISO 9001
www.graco.com
Copyright 03/2008