Graco LineLazer IV Series User manual

311066C
Installation
LineLazer lV
Second Gun Kit 287553
3300 psi (22.8 MPa, 228 bar) Maximum Working Pressure
Important Safety Instructions
Read all instructions and warnings in manuals 311020,
311021, or 313775. Save these instructions.
ti6545a
ENG

2311066C
Relieve pressure. Refer to
your sprayer manual.
1 Install extension clamp (10)
and extension support
bracket (12))
a Pull out existing gun arm
support bracket
b Slide extension clamp onto
existing gun arm support
bracket
ti6654a
ti6655a
ti6656a
c Install existing gun support
bracket.
2 Install extension support
bracket (12). Tighten exten-
sion clamp (10).
3 Route gun cable (1) up to
cable bracket on handle
bar. Remove knurled nut
near end of gun cable.
4 Insert gun cable through
cable bracket. Install and
tighten knurled nut.
ti6657a
ti6658a
ti6659a
ti6660a
5 Insert gun cable in gun
selector plate
6 Remove plug from filter. 7 Connect paint hose to filter. 8 Adjust cable and gun trig-
ger so both guns trigger at
the same time.
ti6661a
ti6662b ti6663a
ti6665a

311066C 3
1 Align guns 2 Position guns: up/down,
forward/reverse, left right
3 Connect gun cables to left
or right, or both, selector
plates
a One gun: Disconnect one
gun selector plate from trig-
ger.
b Both guns simultaneously:
Adjust both gun selector
plates to the same position.
c Solid-skip and skip-solid:
Adjust solid-line gun to
position 1 and skip-line gun
to position 2.
ti6664a
ti6549a
1
2ti3330a
ti3331a
ti3332a
ti3342a
a
b
c

4311066C
ti6546b
11
13
1
8
5
5c
12
4
9
7
22
2
10
3
5a
5b
5a
5d
5e
5f
6
23
Ref Part Description Qty
1 287696 CABLE, gun 1
2 15F212 ARM, holder, gun 1
3 119648 SCREW, mch, trsshd, cross recess 1
4 287566 KIT, clamp 1
5 287570 HOLDER, gun; includes 5a - 5f 1
5a 102040 NUT, lock 4
5b 15F209 STUD, trigger pull 1
5c 15F214 LEVER, actuator 1
5d 15F211 STUD, cable 1
5e 15F210 STUD, pivot 1
5f 287569 HOLDER, GUN 1
6 119647 SCREW, cap, socket, flthd 2
7 15F213 BRACKET, cable 1
8 111145 KNOB, pronged 1
9 188135 GUIDE, cable 1
10 224136 CLAMP, extension 1
11 248157 GUN, flex, basic 1
12 224096 BRACKET, support, extension 1
13 245798 HOSE, 1/4 in. X 7 ft 1
22 15F624 NUT, cable, gun (knurled) 2
23 196177 FITTING, adaptor 1
Ref Part Description Qty

311066C 5

6311066C
For the latest information about Graco products, visit www.graco.com.
TO PLACE AN ORDER, contact your Graco distributor or call 1-800-690-2894 to identify the nearest distributor.
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
Original instructions. This manual contains English. MM 311066
Graco Headquarters: Minneapolis
International Offices: Belgium, Korea, China, Japan
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441
Copyright 2005, Graco Inc. is registered to ISO 9001
http://www.graco.com
Revised 01/2011