Graco Modes Sport Click Connect User manual

Graco® PD255849C 11/2013
Graco® Modes SportTM
Click ConnectTM
Multi-Stage Lightweight Stroller

Failure to follow these warnings and the
assembly instructions could result in serious injury or death.
sPLEASE SAVE OWNER’S
MANUAL FOR FUTURE USE.
sADULT ASSEMBLY REQUIRED.
sNEVER LEAVE CHILD
UNATTENDED. Always keep
child in view while in stroller.
sAVOID SERIOUS INJURY from
falling or sliding out. Always use
seat belt or infant carseat
harness. After fastening buckles,
adjust belts to get a snug fit
around your child.
sAVOID FINGER ENTRAPMENT:
Use care when folding and
unfolding the stroller. Be certain
the stroller is fully erected and
latched before allowing your
child near the stroller.
sNEVER USE STROLLER ON
STAIRS or escalators. You may
suddenly lose control of the
stroller or your child may fall out.
Also, use extra care when going
up or down a step or curb.
sAVOID STRANGULATION.
DO NOT place items with a
string around your child’s neck,
suspend strings from this
product, or attach strings to toys.
sUSE OF THE STROLLER with a
child weighing more than 50 lbs
(22.7 kg) or taller than 45in
(114.3cm) will cause excessive
wear and stress on the stroller.
Use the stroller with only one
child at a time.
sALWAYS check that the infant
carseat or toddler seat is securely
attached to the frame by pulling
up on it.
sTO PREVENT A HAZARDOUS,
UNSTABLE CONDITION, never
place purses, shopping bags,
parcels or accessory items on the
handle (other than approved
Graco stroller bags). Never place
anything on the canopy.
sTO PREVENT A HAZARDOUS,
UNSTABLE CONDITION, do not
place more than 10 lbs (4.5 kg)
in the storage basket.
sTO AVOID BURNS, never put
hot liquids in the parent tray.
sTO PREVENT TIPPING, do not
place more than 3lb (1.36kg) in
the parent tray.
sDO NOT use storage basket as a
child carrier.
sDO NOT use toddler seat in an
automobile.
sDO NOT use toddler seat as a car
bed or booster seat.
sDO NOT remove, reverse or carry
the toddler seat while child is in
it.
sDO NOT ALLOW your child to
stand on the basket. It may
collapse and cause injury.
sNEVER PLACE child in the
toddler seat with head toward
footrest.

sDO NOT use stroller frame
without toddler seat or carseat
attached.
sNEVER ALLOW YOUR
STROLLER to be used as a toy.
sSTROLLER TO BE USED only
at walking speed. Product not
intended for use while jogging,
skating, etc.
sNEVER LIFT OR CARRY toddler
seat by the footrest.
sDISCONTINUE USING YOUR
STROLLER should it become
damaged or broken.
sCAREGIVER MUST always help
child get into and out of the
stroller.
sCAREGIVER MUST always
ensure the brakes are engaged
when placing child into stroller.
sUSING GRACO® INFANT
CARSEAT WITH STROLLER:
sUSE ONLY A GRACO®
SNUGRIDE®CLICK CONNECT™
infant carseat with this product.
(Not intended for use with
SnugRide®, SnugRide® 30,
SnugRide® 32, SnugRide® 35,
Infant Safeseat™, AUTOBABY,
LOGICO S, JUNIORBABY and
ASSURA infant car seats.)
Improper use of this stroller with
other manufacturers’ carseats
may result in serious injury or
death.
sREAD THE MANUAL provided
with your Graco carseat before
using it with your stroller.
sFALL HAZARD: Always check
that infant carseat is securely
attached to stroller by pulling up
on the carseat.
sTO AVOID FALLING OUT
always ensure that the toddler
seat is securely attached on both
sides of the stroller frame.
sALWAYS SECURE your child
with the carseat harness when
using the carseat in the stroller.
If your child is already in the
carseat, check that the child is
secured with the harness.
sImproper use of this stroller with
a carseat may result in serious
injury or death.
sSee Graco infant carseat owners
manual for maximum size of
child.

Check that you have all the parts for this model BEFORE assembling
your product. If any parts are missing, call Customer Service.
!LLMODELS
0ARTSLIST
2X 2X 2X
No tools required.
2X

To Open Stroller
1
2CHECK that stroller is
completely latched open
before continuing.
Before assembly be sure to place stroller on top of a piece of cardboard
or other protective cover to prevent damage to floor surface.
Pull out to unlock
stroller.
SNAP!

2
1
2EAR!XLE
Rotate parking stands up
and snap onto axle tube.
SNAP!
SNAP!
SNAP!
Brake levers point toward rear
of stroller. Check that rear
axle is securely attached by
pulling on brake assembly.

Fasten basket around rear axle
as shown.
3

1
2X 2X
2EAR7HEELS
0ARENT4RAY
SNAP!
SNAP!
1
Firmly attach hub
adapter onto wheel.

2Attach wheel as shown.
Repeat on other side.
Push straight side of pin
through axle hole. Pin will
separate around the axle. Curved
end of pin MUST face out as
shown. Repeat on other end.
3
2X

Attach hub cap as shown.
Repeat on other side.
CHECK that wheels are securely
attached by pulling on wheels.
4
2X

CHECK that wheels are
securely attached by pulling
on front wheels.
Front Wheels
1
2
SNAP!
Attach wheel as shown.

To attach seat, place seat on
mounts as shown until they lock
into place on both sides of the
stroller. Seat may be placed on
stroller in either direction.
See warnings for additional
information.
MAKE SURE seat
mounts are securely
attached to the stroller on both
sides as shown.
1
2
To Attach Toddler Seat
SNAP!

1
2
Insert armrests into slots on
each side of the stroller until
they click into place.
Pull on armrest to make
sure they are attached.
#HILDS4RAY
SNAP!
SNAP!
WARNING
Always secure your child with the seat belt. The tray is not a restraint
device.
DO NOT lift the stroller by the child’s tray. Use care when snapping the
tray on the stroller with a child in the stroller.

3
4
To remove tray, squeeze
button on tray and lift up.
To remove armrest, push
button as shown and remove.

#ANOPY
1
Fasten hook and loop tape on
the rear of canopy as shown.
MAKE SURE canopy is always
fastened with the hook
and loop tape when used
with infant carseat or when
toddler seat is in use.

To open canopy.
To close canopy.
2
3

To open canopy window.
4
5To close canopy window.

1
4
2
3
4O3ECURE#HILD
0OINT(ARNESS
Use slide adjuster at shoulder and waist
for tighter adjustment.
To change shoulder harness slots.

2
3
1
0OINT(ARNESS
To convert to 3-pt buckle.
Use slide adjuster at waist
for tighter adjustment.
4
5

To Change Shoulder Harness Slots
1
2
Shoulder harness anchor-larger child
Shoulder harness anchor—smaller child
Slide adjuster
To change shoulder harness slots,
unfasten zipper on rear of seat as
shown.
Push harness anchor through the
front of seat then re-insert through
desired slots at the same height
level.