Graco UNO2DUO User manual

UNO2DUO™
• featuring
• Owner’s Manual
©2018 Graco NWL0000742780B

2-A UNO2DUO™ Use Positions
2-B Parts List
1 WARNING
2 Features
3-A To Open Stroller
3-B Rear Wheels
3-C Front Wheels
3-D Cup holder and Phone holder
3-E Assemble Seat(s)
3 Assembly

4-A To Use Toddler Seat
4-B To Use Toddler Seat in Bassinet Position •
4-C To Extend Platform for Child Use, Extra storage or Rear Seat
Attachment
4-D To Secure Child
4-E To Recline
4-F Brakes
4-G Swivel Wheels
4-H To Attach Graco® Infant Car Seat to Stroller Frame in Front
Position
4-I To Attach Graco® Infant Car Seat to Toddler Seat in Front
Position
4-J To Fold Stroller Frame
4-K Harness Covers
4-L Crotch Strap Cover
4-M To Adjust Handle
4 Use

Failure to follow these warnings and the assembly
instructions could result in serious injury or death.
Only use product as instructed.
PLEASE SAVE OWNER’S
MANUAL FOR FUTURE USE.
ADULT ASSEMBLY REQUIRED.
NEVER LEAVE child
unattended. Always keep
child in view while in stroller.
AVOID SERIOUS INJURY from
falling or sliding out. Always use
seat belt. After fastening
buckles, adjust belts to get a snug
fit around your child.
AVOID FINGER ENTRAPMENT:
Use care when folding and
unfolding the stroller. Be certain
the stroller is fully erected and
latched before allowing your child
near the stroller.
AVOID STRANGULATION:
DO NOT place items with a string
around your child’s
neck, suspend strings from
this product, or attach strings
to toys.
NEVER USE STROLLER ON
STAIRS or escalators. You may
suddenly lose control of the
stroller or your child may fall out.
Also, use extra care when going
up or down a step or curb.
STROLLER TO BE USED only
at walking speed. Product not
intended for use while jogging,
skating, etc.
USE OF THE FRONT SEAT, REAR
SEAT, OR STANDING PLATFORM
with a child weighing more than
50 lb (22.7 kg) or taller than
45 in. (114.3 cm) will cause
excessive wear and stress on the
stroller.
TIPPING HAZARD! DO NOT
OVERLOAD FRONT SEAT, REAR
SEAT, OR STANDING PLATFORM
PAST THE MANUFACTURERS
RECOMMENDED WEIGHT
RATING.
TO PREVENT TIPPING, do not
place more than 1 lb (.4 kg) on
the parent’s cupholder or phone
holder.
TO AVOID BURNS, never put hot
liquids in the parent’s cupholder.
TO PREVENT A HAZARDOUS,
UNSTABLE CONDITION, never
place purses, shopping bags,
parcels or accessory items on the
handle or canopy.
TO PREVENT A HAZARDOUS,
UNSTABLE CONDITION, do not
place more than 10 lb
(4.5 kg) in the storage basket.
DO NOT use storage basket as a
child carrier.
NEVER ALLOW YOUR
STROLLER to be used as a toy.
DISCONTINUE USING YOUR
STROLLER should it become
damaged or broken.

ONLY USE THE TODDLER
SEATS PROVIDED WITH THIS
STROLLER OR PURCHASED
SEPARATELY AND SPECIFIED
FOR USE WITH THIS
STROLLER.
USING GRACO® INFANT CAR
SEAT WITH STROLLER:
• TO AVOID INJURY TO YOUR
CHILD: THIS STROLLER IS
ONLY COMPATIBLE WITH
GRACO® SNUGRIDE®
INFANT CAR SEATS WITH
CLICK CONNECT™. Only use
with Graco®
infant car
seats that
have the Click
Connect™
logo. Improper
use of this stroller with other
manufacturers’ car seats may
result in serious injury or
death.
• READ THE MANUAL provided
with your Graco car seat
before using it with your
stroller.
• ALWAYS SECURE your child
with the car seat harness when
using the car seat in the
stroller.
If your child is already in the
car seat, check that the child is
secured with the harness.
• NEVER ATTACH infant car seat
in the toddler seat without the
child’s tray and side armrests
attached.
• ONLY USE toddler seat on the
stroller and do not remove,
reverse, or carry the toddler
seat while child is in it.
• ONLY USE bassinet on the
stroller and do not remove,
reverse, or carry the bassinet
while child is in it.
• ALWAYS release the webbing
strap buckle to lower the foot
end of the toddler seat before
placing child in the bassinet.
• TIPPING HAZARD: Stroller
could tip backwards. Do not
allow child to step on or off the
rear platform without caregiver
assistance.
• FALL HAZARD: Never allow
child to stand on the rear
platform when going up or
down curbs or steps.
• ALWAYS LOCK BRAKES before
folding.
10

2-A UNO2DUO™ Use Positions
WARNING
DO NOT allow child to stand on
platform facing backwards. To avoid
falling, child must hold onto frame.
One Child
Extra Storage - Frame can be extended in any of the 8
use positions above.
Infant car seat on certain models or sold separately)

Two Children
separately)
Second Seat (on certain models or sold

2-B Parts List
All models
2X 2X
This model may not include some
features shown below. Check that
you have all the parts for this
model.
Tools required:
Phillips Screwdriver
2X
On certain models
2X
2X
2X

3-A To Open Stroller
1. Open stroller lock.
Be sure to place stroller on top of a piece of cardboard or some other
protective cover to prevent any damage to floor.
Zip ties
WARNING
• Remove and IMMEDIATELY discard the zip ties.

3. CHECK that the stroller is
completely latched open every
time you open the stroller and
before continuing with the rest of
the assembly steps.
2. Lift handle of stroller up.
SNAP!

3-B Rear Wheels
Fenders
1. Attach fender with extension
facing the rear of stroller. Insert
tabs into stroller frame and slide
to secure.
2. Secure with screw.
Extension
Repeat on other fender.
Extension

Rear Axle
1. Remove protective end cap from
each axle end.
2. Insert axle through axle opening.

3. Place wheel on axle.
2X
4. Place washer on axle.
Rear Wheels

6. Snap hubcap over pin as shown.
Repeat with other hubcap.
5. Push straight side of pin through
axle hole. Pin will separate
around the axle. Curved end of
pin MUST face up as shown.
Repeat steps 3-5 on other side.
2X
SNAP!

3-C Front Wheels
1. Attach front wheels to front leg
tubes as shown.
2. CHECK that wheels are securely
attached by pulling on wheel
assembly.
2X
SNAP!

3-D Cup holder and Phone holder
1. Line up opening in cup holder
or phone holder with mount on
stroller and press onto stroller
tube.
2. Make sure cup holder or phone
holder is snapped securely into
mount.

3-E Assemble Seat(s)
2. Insert seat wire into openings
marked with an arrow on sides of
toddler seat.
CHECK that seat wire is securely
attached to toddler seat by pulling
on it.
1. Seat wire should be inserted as
shown. DO NOT insert with wire
facing head end of seat.
Arrow
SNAP!

3. Secure flap around wire with 3
snaps. Repeat on other toddler
seat (on certain models).
1. Slide canopy pivots onto mounts
on each side of the toddler seat
as shown.
Canopy
Toddler Seat - 3 panels with visor
Second Seat (on certain models) - 2 panels with visor
SNAP!

2. Fasten hook and loop tape on the
rear of canopy as shown. MAKE
SURE canopy is always fastened
with the hook and loop tape when
toddler seat is in use.
(on certain models)
Repeat steps on second seat.

Child’s Tray
WARNING
Always secure your child with the seat belt. The tray is not a restraint
device. DO NOT lift the stroller by the child’s tray. Use care when
snapping the tray on the stroller with a child in the stroller.
1. Insert side armrests into slots on
each side of seat until they click
into place.
Pull on armrests to make sure
they are attached.