Graham Field Basic American A919000 Parts list manual

SAFETY GUIDELINES — READ BEFORE USE
WARNING: Important: Read and understand these instructions before installing or using the
Overbed Table. If you do not understand any part of these instructions, contact a healthcare
professional for direction in the use of this product. If the overbed table is not properly assembled
and adjusted, personal injury and/or damage to the overbed table could result.
WARNING: If components are damaged or missing, contact your Graham-Field authorized
distributor immediately. DO NOT use substitute parts. Non-Basic American replacement
parts could cause personal injury and damage to the Overbed Table.
WARNING: GF Health Products, Inc. ("GF") assumes no responsibility for any damage or
injury caused by improper assembly or service of this product.
UNPACKING
1. Open the box and inspect for any
damaged or missing components.
If damage is evident, DO NOT USE.
Contact carrier / distributor for
further instruction.
2. During assembly, refer to pictures
that follow to identify components.
A919xxx Overbed Table
column
table top
base
non-locking
(swivel) casters
locking casters
release
lever
BA_A9190-INS-LAB-RevB23
A919000: OVERBED TABLE,
ASSEMBLY & OPERATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE USE

ASSEMBLY INSTRUCTIONS
Tools required: #2 Phillips-head screwdriver, 9/16 or M17 open-end wrench, 3/16 or M5 hex key
Assembly (see pictures below)
WARNING: The table is shipped with a column retainer screw, shown below in
step 2, to prevent the column from changing height.
DO NOT remove the column retainer
screw fully from the column until step 8 below is complete; the table top could rise suddenly
and cause serious personal injury.
1. Place table top upside down on level surface.
step 2
Phillips screw
(8 each)
bracket
table top
column
column retainer
screw
release
lever
steps 3 - 4
lock washer
(4 each)
flat washer
(4 each)
caster
(4 each)
base
2. Attach column to table top as shown at above left in step 2 using eight #8 x 5/8" screws; use
#2 Phillips-head screwdriver to hand tighten.
3. Assemblecasterswithsuppliedhardware:installlockwasher,thenatwasher,oneachcaster
as shown at above right in steps 3-4.
4. Screw each caster, assembled with washers as described in step 3, and shown at above right
in steps 3-4, into base. Use 9/16 or M17 open-end wrench to tighten.
WARNING: Removing retaining screw will cause column to rise.
5. Remove retaining screw with #2 Phillips-head
screwdriver. Once the retaining screw is out
and column has risen, place the retaining
screw in the second (upper) position.
Use
3/16 or M5 hex key to remove the four
M6 x 20mm socket head cap screws mounted
on bottom of column shown at right in step 5.
6. Mount base to column using four M6 x 20mm
socket head cap screws removed in step 5, as
shown at right in step 6; use 3/16 or M5 hex key
to tighten.
7. Turn entire assembly over, upright, with casters
ontheoor.
8. Use #2 Phillips-head screwdriver to remove the column retainer screw fully, shown above in
step 2; table height will now be adjustable.
step 6
column
base
M6 x 20mm
socket head
cap screw
(4 each)
step 5
2
BA_A9190-INS-LAB-RevB23 www.grahamfield.com

WARNING: Ensure the table is assembled as described, and that all components are
securely attached before use.
OPERATION INSTRUCTIONS
WARNING: Do not lean on the suspended end of the table top; this may cause the table
to tip.
WARNING: The table supports up to 100 lb (45 kg) of dispersed weight, EVENLY
DISTRIBUTED. Do not exceed this limit.
To raise the table top
To raise the table top, apply light pressure
upward at any point on bottom of table top
and stop when the table top has reached the
desired height.
To lower the table top
To lower the table top, squeeze the release
lever, circled in red at right, upward while
pushing the table top down at the column until
the table top has reached the desired height.
DO NOT put pressure on the table top end
opposite the column. The column will lock
when the lever is released.
To lock and unlock casters
The two column-end casters have step-on
locks, circled in red at right. Step on the locks
to lock the casters; pull the locks up to unlock
the casters.
MAINTENANCE
Checkthetandtightnessfrequentlyofallhardwaretoensurethatthetableissecurely
assembled.
Cleaning
1. To clean: Gently wipe the table with a soft, clean, damp cloth.
sNOTICE: Do not use cleansers that may damage the table's nish.
2. To wash more thoroughly: Clean with mild soap and water.
3. Dry table with a clean, soft cloth.
lock and unlock casters
lower the table top
3
BA_A9190-INS-LAB-RevB23 www.grahamfield.com

LIMITED WARRANTY
SCOPE OF WARRANTY
GF Health Products, Inc. (“GF”) warrants to the original purchaser only that it will replace or repair components, at GF’s sole
discretion, that are defective in material or workmanship under normal use and service. All warranties are conditioned
upon the proper use of the products strictly in accordance with good commercial practice and applicable GF instructions
and manuals, including proper use and maintenance. To the extent that a third party warrants a component, GF conveys
all of its rights under that warranty to the original purchaser, to the extent permitted.
This limited warranty shall only apply to defects that are reported in accordance with the provisions set forth in this
warranty document, within the applicable warranty period and which, upon examination by GF or its authorized
representative, prove to be a warranty item. (See Obtaining Warranty Service below) This limited warranty is not
transferable.
The warranted components and time periods are set forth below:
Column / Base Assembly:........................................1 (one) year
Caster Bag Assembly ..................................................90 days
TableTop:...............................................................................5(ve)years
* Labor is not included in the warranty.
‡ The warranty period is as designated above. If a part is replaced under warranty, the original warranty period will not
beaected.Allotherreplacementpartswillbesubjecttothewarrantyperiodspecied.
The applicable warranty period shall commence from date of shipment to the Original Purchaser, unless there is an
expiration date on the component in which case the warranty shall expire on the earlier of warranty period or the
expiration date.
OBTAINING WARRANTY SERVICE
Customers located in the United States who wish to report a warranty issue, must contact GF directly by calling
1.770.368.4700orbye-mailingarequesttocs@grahameld.com.CustomerslocatedoutsidetheUnitedStatesmust
contact the Distributor from whom they purchased the products. In both cases, further directions will be provided once
the initial contact is made. This limited warranty shall only apply to defects that are reported within the applicable warranty
period.Failuretoabidebythespecicdirectionswillresultindenialofthewarrantyclaim.
The warranty does not cover and GF shall not be liable for the following:
1) Defects, damage, or other conditions caused, in whole or in part, by misuse, abuse, negligence, alteration, accident,
freight damage, tampering or failure to seek and obtain repair or replacement in a timely manner;
2)Productswhicharenotinstalled,used,orproperlycleanedandmaintainedasrequiredintheocialmanualforthe
applicable product;
3)Productsconsideredtobeofanon-durablenatureincluding,butnotlimitedto:lters,fuses,gaskets,lubricants,
and charts;
4) Accessories or parts not provided by GF;
5) Matching of color, grain or texture except to commercially acceptable standards;
6)Changesincolorcausedbynaturalorarticiallight:
7) Charges by anyone for adjustments, repairs, replacement parts, installation or other work performed upon or in
connection with such products which are not expressly authorized in writing, in advance, by GF;
8) Any labor or shipping charges incurred in the replacement part installation or repair;
9) Costs and expenses of regular maintenance and cleaning; and
10) Representations and warranties made by any person or entity other than GF.
ENTIRE WARRANTY, EXCLUSIVE REMEDY AND CONSEQUENTIAL DAMAGES DISCLAIMER
THIS WARRANTY IS GF’S ONLY WARRANTY AND IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. GF
MAKES NO IMPLIED WARRANTIES OF ANY KIND INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE. IF ANY MODEL OR SAMPLE WAS SHOWN TO THE CUSTOMER, SUCH MODEL
OR SAMPLE WAS USED MERELY TO ILLUSTRATE THE GENERAL TYPE AND QUALITY OF THE PRODUCT AND NOT TO
REPRESENT THAT THE PRODUCT WOULD NECESSARILY CONFORM TO THE MODEL OR SAMPLE IN ALL RESPECTS.
THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT OF THE DEFECTIVE PARTS. GF SHALL NOT BE LIABLE
FOR AND HEREBY DISCLAIMS ANY DIRECT, SPECIAL, INDIRECT, INCIDENTAL, EXEMPLARY OR CONSEQUENTIAL
DAMAGES, INCLUDING, BUT NOT LIMITED TO: DAMAGES FOR LOSS OF PROFITS OR INCOME, LOSS OF USE,
DOWNTIME, COVER, OR EMPLOYEE OR INDEPENDENT CONTRACTOR WAGES, PAYMENTS AND BENEFITS. CERTAIN
STATES MAY CONFER ADDITIONAL RIGHTS REGARDING WARRANTIES AND IN THOSE STATES GF’S LIABILITY AND THE
LIABILITY OF GF’S SUPPLIERS, SHALL BE LIMITED TO THE FULLEST EXTENT PERMITTED BY LAW.
The warranties contained herein, together with GF’s current Terms and Conditions, contain all the representations and
warranties with respect to the subject matter of this document, and supersede all prior negotiations, agreements and
understandings with respect thereto. The recipient of this document hereby acknowledges and represents that it has not
relied on any representation, assertion, guarantee, warranty, collateral contract or other assurance, except those set out in
this document.
For additional information on this product or this warranty, please contact a GF Customer Service Representative.
NOTES:
1) Additionaltermsandconditionsmayapply.SeeGF’sGeneralTermsandConditionsonitswebsite:www.grahameld.
com.
2) Freight claims must be notated on the appropriate shipping documents and must be made with immediacy.
International,federalandstateregulationsgovernspecicrequirementsforfreightclaims.Failuretoabidebythose
regulationsmayresultinadenialofthefreightclaim.GFwillassistyouinlingthefreightclaim.
3) Claims for any short shipment must be made within three (3) days of the invoice date.
4
BA_A9190-INS-LAB-RevB23 www.grahamfield.com

+1 770.368.4700
Information contained herein is subject to change without notice.
The most current and complete product information can be found on our website.
BA_A9190-INS-LAB-RevB23 www.grahamfield.com
© 2021, GF Health Products, Inc. All Rights Reserved.
Basic American Medical Products is a trademark
of GF Health Products, Inc.
GF Health Products, Inc.
One Graham-Field Way, Atlanta, GA 30340
Top Made in USA
Base Made in Taiwan
Manufactured By: