Granberg 333 Installation guide

2023-08-30
Operating / Care instructions Changing table 333
1. Operating instructions
Height adjustable baby changing table.
Press and hold the button to start the operation. The height above floor is shown in the display.
Release the button when the changing table is at the desired level.
Pos. 1
Control button
Save height position in the memory:
Run to the desired height, press once on the S and then again at the memory location you wish. (1-4)
Push button 1-4 to adjust the height to the memory position.
(For reasons of safety the button must be held down throughout the journey.)
2. Maintenance
The changing table is maintenance-free. Greasing and other actions are made during the manufacturing for the
lifetime of the lift. From safety point of view however some components shall be inspected each year.
Inspections, service and repair work shall be made by competent persons.
Remove any objects from the changing table before maintenance and repair works are made.
3. Functional test
Minimum distance to any adjacent fitting must be at least 50 mm.
If the distance from the changing surface to a wall or an adjacent fitting is less than 50 mm, a pinching
hazard exists.
Check that the changing table is firmly in place. If necessary, adjust the adjustable feets under the frame.
Run the changing table down and up all the way to respectively end position. Check that it moves freely,
without hindrance and jarring sounds.
Check that no cables are jammed.
If the changing table does not reach the lowest position:
Press the down button for 5 seconds until the control box clicks. When the control box clicks the
synchronisation is ok.
Model with sink:
Run the changing table to the end position and make sure the hoses are long enough above the fixing point.
Granberg United Kingdom - Bellamy House Winton Road - Petersfield, Hampshire GU32 3HA - United Kingdom
Tel. [phone] - Email: [email protected] - Web: https://www.granberg-uk.co.uk/

4. Cleaning
Clean with lukewarm water and a non-scratching detergent containing soap or similar. Use a soft cloth or similar.
After cleaning the surfaces shall be dried to avoid lime deposits.
Scratching detergents or tools e.g. steel wool may not be used.
Consider that the product contains electrical components.
Cleaning the plastic surface - ABS plastic:
The surface is easy to keep clean. Use cleaning spirit to ensure hygiene.
Do not use abrasive or corrosive cleaning agents, this might damage the finish.
5. Service & maintenance records
Order Serial Date
Date
Sign
Remarks
Date
Sign
Remarks
Date
Sign
Remarks
Date
Sign
Remarks
Powered by TCPDF (www.tcpdf.org)
Granberg United Kingdom - Bellamy House Winton Road - Petersfield, Hampshire GU32 3HA - United Kingdom
Tel. [phone] - Email: [email protected] - Web: https://www.granberg-uk.co.uk/