＜
＜＜
＜350Z GT Wide Fender Kit
350Z GT Wide Fender Kit350Z GT Wide Fender Kit
350Z GT Wide Fender Kit＞
＞＞
＞
This product is meant to fit Nissan 350Z only. Please check the parts before mounting.
■
■■
■
Parts List
Left & Right Front Fender
Left & Right Front FenderLeft & Right Front Fender
Left & Right Front Fender
×
××
× 1
1 1
1 Each
Each Each
Each
Left & Right Rear Fender
Left & Right Rear FenderLeft & Right Rear Fender
Left & Right Rear Fender
×
××
× 1
1 1
1 Each
Each Each
Each
Fuel Lid with Key lock
Fuel Lid with Key lockFuel Lid with Key lock
Fuel Lid with Key lock
×
××
×
1
11
1
Key for Fuel Lid
Key for Fuel LidKey for Fuel Lid
Key for Fuel Lid
×
××
×
2
22
2
Double Sided ape
Double Sided apeDouble Sided ape
Double Sided ape（
（（
（1.2
1.21.2
1.2×
××
×10
1010
10×
××
×2.5m
2.5m2.5m
2.5m）
））
）
×
××
×
4
44
4
Rivets
Rivets Rivets
Rivets （
（（
（4mm
4mm4mm
4mm）
））
）
×
××
×
50
5050
50
■
■■
■
Mounting Procedure
Mounting ProcedureMounting Procedure
Mounting Procedure
1)
1)1)
1)
Remove the factory fuel lid from the vehicle.
Remove the factory fuel lid from the vehicle.Remove the factory fuel lid from the vehicle.
Remove the factory fuel lid from the vehicle.
2)
2)2)
2)
emporarily tape the fenders onto the body to get them in the correct positioning.
emporarily tape the fenders onto the body to get them in the correct positioning.emporarily tape the fenders onto the body to get them in the correct positioning.
emporarily tape the fenders onto the body to get them in the correct positioning.
Mark the mounting points so you are able to drill in the correct positions.
Mark the mounting points so you are able to drill in the correct positions.Mark the mounting points so you are able to drill in the correct positions.
Mark the mounting points so you are able to drill in the correct positions.
Drill the holes and attach the r
Drill the holes and attach the rDrill the holes and attach the r
Drill the holes and attach the rivets.
ivets.ivets.
ivets.
3)
3)3)
3)
Cover any raw metal with touch up paint or rust stop.
Cover any raw metal with touch up paint or rust stop.Cover any raw metal with touch up paint or rust stop.
Cover any raw metal with touch up paint or rust stop.
Installation is complete.
Installation is complete.Installation is complete.
Installation is complete.
Note 1： This job is recommended for 2 people.
Note 2： Temporarily mount the fenders to check fitment before painting.
Note ３： Be sure to use a surface degreaser and sand the material before applying primer and paint.
