Grizzly G0625 Quick start guide







REF PART # DESCRIPTION
1 P0625001 BED EXTENSION
2 P0625002 RUBBER FOOT
3 PN08 HEX NUT 3/8-16
4 PW01M FLAT WASHER 8MM
5 PSB40M CAP SCREW M8-1.25 X 35
6 PAW06M HEX WRENCH 6MM
Refer to the Model G0624 manual for instructions
on operating the lathe.
If you need help with your new extension table,
call our Tech Support at: [phone].
— If the extension table tilts down, use a
strip of masking tape along the bottom
edge of the lathe to shim the table up
(Figure 3).
— If the extension table tilts up, use a strip
of masking tape along the top edge of the
lathe to shim the table down (Figure 4).
— If the extension table is skewed to the left
or right, use a vertical strip of masking tape
along the corresponding edge of the lathe
to make the extension table parallel with
the lathe (Figure 5).
Figure 3. Shimming extension table up.
Figure 4. Shimming table down.
Figure 5. Shimming table to the left.
Masking
Tape
Masking
Tape
Masking
Tape
G0625 Parts Breakdown and List
Lathe
Extension
Table
Lathe
Extension
Table
Lathe
Extension
Table