Growatt SPF 5000TL User manual

Dyness battery and Growatt off grid inverter Setup
Check List:
Dyness Powerbox F-10.0
Power cable
Communication cable
Growatt SPF 5000TL HVM-P
Before start, make sure battery and inverter size match.
Follow Dyness user manual to check details, it is recommended to
use battery in 1: 2 configuration.
In our case now, 5kW inverter connects to 10kWh battery.
Step 1 : Cable connect in inverter
Keep both inverter and battery completely off.
Connect power cable and comm cable to inverter first.
Note: Comm cable has label on, make sure the inverter side goes
to battery side, inverter side to the inverter BMS side ,battery side
left for later on in battery connection.

Step 2 : Dial DIP switch on master
Make sure master battery is dialed as below method.
OFF ON ON OFF
Step 3 : Cable connect in battery
Keep battery off, connect power cable and comm cable to battery.
When you are installing a Powerbox, there are two scenarios.
Single comm port – battery comm cable go in here.
Dual comm port – battery comm cable go top interface as shown.
When you are installing loose batteries like B4850/B3, battery
comm cable goes to master battery “IN” comm port.

Step 4 : Breaker/Fuse between inverter and battery
Connect DC breaker or Fuse between inverter and battery to protect
both products.
Step 5 : Power on inverter AC/Grid
Power on inverter and turn on inverter’s switch.
Step 6: Power on battery
Long press 3s power switch on Powerbox to power on battery, when
its loose battery like B4850/B3, 3s also on master SW to power on
all batteries.

Step 7: Power on DC breaker
Power on DC breaker of Powerbox.
Step 8: Power on DC breaker between battery and inverter.
Powerbox’s breaker has been powered on, but power on the DC
breaker between inverter and battery again!
If you are installing loose battery like B4850/B3, power on DC
breaker between inverter and battery now.
Step 9: Battery and inverter are connected!
Now inverter is started and buzzing while connecting battery.
A few seconds later, it should show battery voltage and output
voltage. Battery and inverter are connected!
Up and Down button to check the battery status like voltage soc etc..

Step 10: Inverter setup
Long press ENTER, go in, make sure 05 are properly set as
below:
05 LI type(Lithium)
Step 11: You are ready to go
Step 12: Shut Down
POWEBOX
1 Remove all the load
2 Turn off DC breaker of Powerbox.
3 Long press 3s Reset button of the Powerbox to power off battery
4 Disconnect PV/Grid
5 Turn off the inverter power switch,shut down the inverter

B4850/B3 Parallel
1 Remove all the load
2 Turn off DC breaker between the battery and inverter.
3 Disconnect PV/Grid
4 Turn off the inverter power switch,shut down the inverter
5 Long press SW button to power off the battery,from the master to
the slaves one by one.Then switch off all the batteries’ Power switch