
WARNING: ALWAYS read and understand all warnings, cautions, installation and use
instructions prior to installing or using this product. Failure to follow all warnings, cautions
and instructions may result in serious injury or damage to personal property.
ALWAYS wear appropriate safety gear such as ANSI-approved safety goggles and proper work
gloves/gear when using your ATV/UTV.
NEVER allow other persons to install or use this product until they have read this manual and
have developed a thorough understanding of how the product works.
NEVER leave children unattended near the product. Not intended for use by children.
NEVER exceed the manufacturer's weight rating of your ATV/UTV hitch. If you are unsure,
always refer to the original ATV/UTV owner's manual.
ALWAYS maintain proper balance and weight distribution of your ATV/UTV, you may need to
add weight to the opposite end of the ATV to counter weight the load.
CAUTION: Operating an ATV/UTV with accessories or additional implements secured to the
ATV may effect the handling of the ATV/UTV, including breaking, steering, stopping and
turning.
CAUTION: Implements may be heavy, use caution when installing or removing any
implements. Assistance may be required.
WARNING: NEVER exceed 5 MPH when operating or traveling with implements attached to
your ATV/UTV. Excessive speeds can result in loss of control and can cause serious personal
injuries or death.
NEVER operate your ATV/UTV on steep inclines while using this product, tipping or roll overs
can occur.
NEVER carry passengers on your ATV/UTV unless your ATV/UTV is designed to carry more
than one person .
ALWAYS keep hands and feet away from all implements while operating the ATV/UTV.
NEVER get under or between any implement while installing the product or operating the
ATV/UTV.
ALWAYS be aware of pinch points to prevent injury.
NEVER install or operate this product while you are tired or under the influence of drugs or
alcohol.
The warnings, cautions, and instructions in this manual cannot cover all possible conditions or
situations that could occur. Exercise common sense and caution when using this product.
Always be aware of the environment and ensure that the product is used in a safe and
responsible manner.
ALWAYS thoroughly inspect your product for loose parts and/or signs of damage prior to each
use, installation or removal. Using correct wrenches, inspect all nut & bolt assembly locations
and snug up any that may be loose. Be careful not to crush tubing when tightening!
NEVER use the product until any loose parts have been properly secured or damaged parts
have been properly replaced.
MAINTENANCE BEFORE EACH USE:
ALWAYS inspect all nut and bolt assemblies, hardware, and components for damaged,
missing, or loose parts.
ALWAYS inspect entire product for any rust, corrosion, cracks, freezing, excessive heat or
rotting damage that may affect the safety of your product. Discard any questionable product.
ALWAYS inspect entire product for any structural damage - pay close attention to all weld
locations.
NEVER use the product until any loose parts have been properly secured or damaged parts
have been properly replaced.
702141 - Guide Gear® Disc Plow