Safety Information and Warnings
Items In The Box
• Avoid installation behind a door.
• Use only the voltage specified on the rating plate of the heater.
• Do not cover or restrict airflow to the inlet or exhaust grilles in any manner as the appliance may overheat
and become a fire risk (for Fan Heaters).
• Do not cover grilles, block entry or exhaust of airflow by placing appliance against any surface. Keep all
objects at least 1 metre from the front and sides of the appliance.
WARNING: FIRE RISK EXISTS IF THE HEATER IS COVERED BY OR
POSITIONED CLOSE TO CURTAINS OR OTHER COMBUSTIBLE MATERIALS.
• Do not place appliance close to a radiant heat source.
• Do not operate in areas where petrol, paint or other flammable liquids are used or stored.
• This appliance heats up when in use. To avoid burns, do not let bare skin touch hot surfaces.
• Do not use the appliance to dry clothes.
• Do not leave the appliance unattended whilst in use.
• Do not insert or allow foreign objects enter any ventilation opening, as this may cause an electric shock,
fire or damage to the appliance.
• Do not immerse in liquid or allow liquid to run into the interior of the appliance, as this could create an
electrical shock hazard.
• Do not use this appliance on a wet surface, or where it can fall or be pushed into water.
• Do not reach for an appliance that has fallen into water. Switch off at supply and unplug immediately.
• Do not operate any appliance with a damaged cord, plug or after the appliance malfunction or has
been dropped or damaged in any manner. Return to a qualified electrician for examination, electrical or
mechanical adjustment, service or repair before further use.
• Do not operate appliance with wet hands.
• This appliance is intended for household use only and not for commercial or industrial use.
• Use this appliance only as described in this manual. Any other use is not recommended by the
manufacturer and may cause fire, electric shock or injury.
• A common cause of overheating is deposits of dust or fluff in the appliance. Ensure these deposits are
removed regularly by unplugging the appliance and vacuum-cleaning air vents and grilles, where available.
• Do not use this appliance in a window as rain may cause electric shock.
• Do not use abrasive cleaning products on this appliance. Clean with a damp cloth (not wet) rinsed in hot
soapy water only. Always remove plug from the mains supply before cleaning.
• Do not connect the appliance to the mains source until it has been installed in its final location and
adjusted to the position it will be used in.
• Do not operate with the cord coiled up as this could cause a build up of heat, which could pose a hazard.
• The use of an extension cord with this appliance is not recommended.
• Do not remove the power plug from the socket by pulling the cord – grip the plug instead.
• Always unplug appliance when not in use.
• Do not allow cord to come in contact with heated surfaces during operation.
• Do not twist, kink or wrap the cord around the appliance, as this may cause the insulation to weaken and
split. Always ensure that the cord has been fully removed from any cord storage area before use.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
• Young children should be supervised to ensure they do not play with the appliance.
• The appliance must not be located immediately below a socket-outlet.
• Do not use this appliance with a programmer, timer or any other device that switches the heater on
automatically, since a fire risk exists if the appliance is covered or positioned incorrectly.
• If the supply cord is damaged, it must be replaced by a qualified electrician in order to avoid a hazard.
• Do not use this appliance outdoors, or on wet surfaces. Avoid spilling liquid on the appliance.
• In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not
be supplied through an external switching device, such as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
• For additional protection, the use of a Residual Current Device (RCD) with a tripping current not
exceeding 30mA is recommended.
• This heater is not equipped with a device to control the room temperature. Do not use this heater in small
rooms when they are occupied by persons not capable of leaving the room on their own, unless constant
supervision is provided.
• The appliance is designed for wall mounting. If the appliance is used in a bathroom the appliance is to be
installed so that switches and other controls cannot be touched by a person in the bath.
1. Heater Body
2. Wall Plugs for wall-mounting
Contents not shown
Instruction Manual (this document)
Statutory Notice
Warranty card
43
