H-KING MX2 Extreme 4S EP0 User manual

The H-King MX2 3D was designed to be an all-out 3D performer with great, straight precision flying
capabilities. It has a great combination of lightweight, durability, and performance with none of the
compromises normally found in EPO foam aerobatic models. Michael Wargo, our team pilot, and 3D
expert helped fine-tune the MX2 Extreme 3D into the type of plane he enjoys flying. The result is an
aircraft that delivers lightning-fast rolling, amazing straight lines,and extreme tumbling, but it also likes
to perform all of the low and slow 3D maneuvers pilots love.
The MX2 is the perfect aircraft for any pilot wanting a versatile and capable 3D plane. This MX2 is the
next generation of EPO foam designs that are lighter and more capable than ever. Any accomplished
3D pilot will love this plane because it will satisfy the most discriminating pilot. Its high-energy
performance defines this plane, but bring it in low and slow, and it is rock solid and easy to harrier and
hover.
This Plug-N-Fly 3D airplane is very quick and simple to assemble and is supplied in a striking red,
white, and blue pre-printed finish, with carbon landing gear, wheels, and wheel spats. Power is
supplied by the pre-installed 3702-900KV brushless motor driving a fine pitch 13x4 composite
propeller, and a 60A ESC, this is the perfect set-up for excellent throttle response when performing
3D. Also supplied and pre-installed are 4 x 13g high-speed, metal-geared digital servos, these
high-quality servos have an excellent resolution and speed for precise control.
The MX2 Extreme is easy to transport due to its removable wings and is fantastic fun to fly just about
anywhere. If you are looking for an airplane to progress into 3D aerobatic flying, and to take your
flying skills to the next level, then the H-King MX2 Extreme is the perfect choice.
INTRODUCTION:
SPECIFICATIONS:
1
- Wingspan: 1270mm
- Length: 1210mm
- Materials: EPO
- Flying Weight: 1240g (excluding battery)
- Battery: 2200mAh 4S (14.8V) 45~90C LiPo w/XT60 (not supplied)
- Flight Time: Approx 5mins with 2200mAh battery
- Propeller: 13x4
- Radio: 4ch or more
- ESC: 60A brushless with 4A switching BEC
- Motor: 3720-900KV brushless

2

INTRODUCTION:
2
11
1
4
8
10
12
5
6
13
9
15
14
3
1. Fuselage
2. Left main wing
3. Right main wing
4. Wing protectors
5. Rudder
6. Carbon fiber wing joiner rod
7. Wheel spats and wheel sets
8. 13x 4 Propeller
9. Servo Ylead
10. Tail-wheel bracket
assembly
11. Carbon fiber landing gear
12. Spinner
13. Pushrod linkages
14. Wheel spats and wheels
15. Plywood washer
3

ASSEMBLY INSTRUCTIONS:
Horizontal Stabilizer Installation.
Apply a thin coat of foam safe glue to the stabilizer mid-section and gently slide it into place as shown.
Check frequently if the stabilizer is level and square to the fuselage as the glue dries.
A small piece of white foam comes with the
fuselage. Apply some foam safe glue and place
into the slot between the lower part of the rudder
post and the rear of the fuselage to further
reinforce the structure of the empennage.
4