habitat et jardin VivaPool Fresh 4 1155 63310 User manual

Fresh 4
1155_63310

1155_63310
14
2180 mm
X 1
1/1
1
30 mm
X 2
1/1
2
145 mm
X 1
1/1
3
100 mm
X 1
1/1
7
120 mm
X 1
1/1
8
110 mm
X 1
1/1
9
35 mm
X 1
1/1
10
25 mm
X 1
1/1
11
25 mm
X 1
1/1
12
65 mm
X 4
1/1
13
50 mm
X 1
1/1
FR : SAV/INFORMATION /VIDEO/CONTACT
GB: SAV/INFORMATION/VIDEO/CONTACT
DE : KUNDENDIENST/INFORMATIONEN /VIDEO/KONTAKT
ES: SERVICIO POST-VENTA/INFORMACIÓN/VIDEO/CONTACTAR
IT: SERVIZIO ASSISTENZA/INFORMAZIONI/VIDEO/CONTATTO
PT: SERVIÇO PÓS-VENDA/INFORMAÇÕES/VIDEO/CONTATO
PL: SERWIS TECHNICZNY/INFORMACJE/WIDEO/KONTAKT
NE: AFTER SALES SERVICE/INFORMATIE/VIDEO/CONTACT
HE : םע רשקתל/ואדיווה/ עדימ/תוריכמו תוריש רחאל

INSTRUCTION SHEET FOR SOLAR SHOWER
Thank you for choosing our solar shower product. In order to use our products properly and get the most
satisfaction and pleasure, please pay attention to the following details.
1. The solar shower must be installed on solid ground (concrete floor) or concrete base to make sure its
stabilization and safety for user.
2. The solar shower is equipped with base plate, which has 4 prefabricated holes for screws installation on
solid ground or portable base.
3. For easy installation, please separately buy our portable base. Just screw the solar with the base and you
could enjoy the warm water.
4. Please install the solar shower at the location where has the most sunshine.
5. Please connect inlet of the solar shower to tap water system of your home. It is better to have the inlet of
solar shower connected to your garden tap then to the tap water system.
6. Please pay attention that it is necessary to have a tap installed before the inlet of solar shower.
7. To prevent the scalding from the hot water, extra attention to the following.
Before turn on the solar shower, please make sure the valve is at the cold water position (blue), then
turn on the valve and gradually adjust the water toward the hot water position (red), until reach the
most comfortable temperature.
8. Warning! It is made of aluminium and under the exposure of the very strong sun radiations, the water
temperature coming from the solar shower may reach 80 ℃.
Models
Remark for off-season storage protection:
1. After the pool season, please clean the solar shower with soft cloth.
2. Please close the garden tap which is connected to the inlet of solar shower and drain the shower by
unscrewing the drain cover at the back, just below the inlet.
3. While the solar shower is under the dry and frozen environment, the cold and hot water valve should be
in “OPEN” position. The damage caused by frozen temperature will not be covered by our warranty.
Warning:
The damage caused by using mud water, salt water or frozen temperature will not be covered by our
warranty.

MOUNTING THE SHOWER: CONCRETE/MASONRY INSTALLATION ONLY
1. Choose a location for shower that receives the most direct sunlight.
2. Use the main unit to mark the position of the mounting holes to be drilled into concrete/masonry for bolts.
SEE FIGURE 1.
3. Remove shower. Drill 1/2” diameter holes, 13/4” deep, using the marks just created.
4. Insert Expansion Nuts into holes. Place the bolt inside the expansion nut and TAP with a hammer to slightly expand the nut.
5. Remove Bolt and place the base plate/lower tube over the holes and secure to surface with bolts and washers provided.
NOTE: Base plate will appear loose until shower is fully secured to the surface.
Figure 1