habitat et jardin 1536-128810 User manual

Ref：1536_128810
2022-2023

A 200X200X800mm X1 1/1
B 135x45x17mm X1 1/1
C 62mmX75mm X4 1/1
D M6mmx60mm X4 1/1
E M6mm X2 1/1
Fφ6mmx1mm X2 1/1
Gφ6mmx12mm X2 1/1
Ref:1536_128810

Warning
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE,
We cannot be liable for any damages caused by failure to observe these instructions.
CAUTION: FOR OUTDOOR USE ONLY
IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY-The infrared heater is designed for safe operation. Nevertheless, installation,
maintenance and operation of the heater can be dangerous. Observing the following procedures
will reduce the risk of fire, electric shock, injury to persons and keep installation time to a
minimum. Save these instructions for future used.
1. Read all instruction before using this heater.
2. Remove the unit from its packaging and check to make sure it is in good condition before using.
3. Do not let children play with parts of package (such as plastic bags).
4. Check the household voltage to ensure it matches the heater’s rated specification.
5. Check the power cord and plug carefully before used, to make sure that they are not damaged.
6. Before unplugging the power cord, be sure to turn off the power, when energizing the unit, be
sure your hands are dry to prevent from electric shock.
7. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If
provided, use handles when moving this heater. Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater
and keep them away from the sides and rear.
8. Extreme caution is necessary when any heater is used by or near children or invalids and
whenever the heater is left operating and unattended.
9. Do not use near or in the immediate vicinity of a bath or swimming pool or any source of liquid.
10. To protect against electric shock, do not immerse cord or plug in water or any other liquid.
11. Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this may
cause an electric shock, fire, or damage to the heater.
12. Always unplug the heater when not in use.
13. Connect to properly grounded outlets only.
14. Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or
relocatable power tap (outlet/power strip).
15. Do not allow cord to overhang the countertop where it can be easily pulled by children.

16. Do not put fingers or foreign objects into the grill while in operation.
17. Do not leave the appliance unattended when in use.
18. This heater is not intended for use in bathrooms, laundry, and similar indoor locations, never
located heater where it may fall into a bathtub or other water container.
19. No liability can be accepted for any damage caused by noncompliance with these instructions
or any other improper use or mishandling.
20. This appliance is not intended for use by persons (including children) with reduces physical,
sensory, or mental capabilities or lack of experience and knowledge unless they have been given
supervision or instruction concerning the use of the appliance by a person responsible for their
safety. Children and vulnerable people should be supervised to ensure they do not play with the
appliance.
21. Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.
22. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has
been dropped or damaged in any manner. Disconnect power at service panel and have heater
inspected by a reputable electrician before reusing. If the supply cord is damaged in any way, it
must be replaced by the manufacturer or its service agent or a similarly qualified person to avoid a
hazard.
23. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area
and where it will not be tripped over.
24. To disconnect heater, turn controls to off, then remove plug from outlet.
25. To prevent overheating of this appliance, keep the air inlets and outlets clean and free of
anything that may cause blockage. Check all inlets and outlets from time to time to ensure it is
clear of any dirt or dust accumulation. DO NOT COVER.
26. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline,
paint, or flammable liquids are used or stored.
27. Parts of the heater may exceed 200℃, contact with the heating tube, reflector, or metal parts
near the heating tube, may cause severe BURNS. To avoid burns, do not let bare skin touch hot
surface.
28. NEVER place hands under the heating elements. ALWAYS allow heating element to cool at
least 10 minutes before touching the heating tube or adjacent parts.

29. This product contains recyclable materials. Do not dispose this product as unsorted municipal
waste. Please contact your local municipality for the nearest collection point.
SAVE THESE INSTRUCTIONS
Introduction
This robust and weatherproof heater is designed for domestic and commercial heating
applications at outdoor well-protected areas.
Model
Specification
Voltage(V)
220-240V AC
Wattage(W)
1500/2000/2500
Hertz(Hz)
50/60
Dimensions W×H×D(mm)
910×175×10
Weight(KG)
2.8
INSTALLATION
Tools Needed:
* Pencil *Hammer *Level *Screwdriver *Power Drill and drill bits
A wall mounting bracket is provide with the heater which has been specifically designed to allow
this product to be fitted to a ceiling before drilling the holders for the ceiling is solid and that there
are no hidden water pipes or electric wires. The heater must be installed no less than 19.7″from
side walls and no less than 2.4m off the floor.
ATTENTION! The appliance must be installed on the solid surfaces like concrete, wood, or metal
etc.
Important: Ensure that the supply cables are well mounted and that it does not meet reflector of
the heater or that does not trail into heated area, the supply cable can be fixed to the metal
mounting bracket behind heater with plastic zip ties.
1. This heater should be installed by a competent person, i.e., a qualified electrician.
2. Always disconnected the heater from the electricity supply and allow it to cool before
installation.
3. For ceiling mounting, the lowest part of the heater must be located at or above a minimum
height of 2.4m from ground level, so that the heater cannot be touched when in operation.
4. For ceiling mounting, there must be a 2.4m distance from your appliance to the ground.
5. When installed to the ceiling, there must be 0.5m between corners and the appliance.
6. The distance of your appliance from the living beings is to be min 1m.
7. The distance from the front side of the heater to materials such as wood, carton, cloth etc.,
must be min 1m.
8. When mounting to a ceiling, do not position the heater at an angle more than 90°and less than
45°.