hager Dream User manual

www.hager.com
Safety instructions
Electrical equipment must only be installed and assembled by a qualied
electrician in accordance with the relevant installation standards, regulations,
directives and safety and accident prevention directives of the country.
Failure to comply with these installation instructions may result in damage to
the device, re or other hazards.
Function
The shaver socket is installed in a bathroom of a hotel in order to provide safety power
to an electric razor.
Correct use
- According to IEC 60670 installation of the safety shaver socket outlet is only per-
mitted in plastic wall box or metal wall box (metal wall box must be connected with
earth directly).
Observe depth of wall box (depth ≧51 mm).
- Only suitable for use in indoor areas with no drip and no spray water.
Technical data
Rated voltage: 250 V~
Frequency: 50/60 Hz
Output voltage: 115 V~/230 V~
Power: max. 20 VA
Conductor cross-section of screw terminals: min. 1 x 1.5 mm²... max. 2 x 4 mm²
Distance of xing holes: 120.6 mm
Compliance: BS EN 61558
115/230V Shaver socket
Hager Dream Installation manual

2
Information for electricians
Installation and electrical connection
DANGER!
Touching live parts can result in an electric shock.
An electric shock can lead to death.
Disconnect the connecting cables before working on the device and
cover all live parts in the area!
ç
Preparing the device for installation
1
Notches
Cover
Carefully loosen the cover on the notches with a flat-blade screwdriver. Lift up and
remove the cover (1).
Connecting the device
L
N
2A
N
L
with plastic wall box with metal wall box
2B
ç
Strip connection cables approx. 10 ... 15 mm.

3
Wire the shaver socket according to the connection diagram (2A or 2B).
When installing in metal wall box (2B), the box must be connected with earth
directly.
Installing the device into the wall box
3
After wiring, x the device with the two screws attached into the wall box (3).
Assembling the cover
4
Cover
Place the cover in the correct position and snap it onto the device (4).