Haier HLT364XXQ - Genesis Washer User manual

GWT800AW
WD-8888-92 Edition: 2006.06.27
Full automatic washing machine
Models
HLT364XXQ
SERVICE MANUAL

CONTENTS
1. Contents 1
2.
3. Specifications
4.
5. 5
6. Net dimension 6
7. 6
8.Operating instructions 8
9. Maintenance service and trouble shooting 14
10. Wiring diagram 18
11. 19
Features 2
3
Safety precautions 4
Warning and cautions
Installation and accessory parts
How to disassemble washing machine
1

FEATURES
Haier frenquency-cenvsion and double drive
blanket washing easily
Shift washing, shift spinning
VFD Display
Cold & warm water inlet selection
Drain up function
Cabinet with the door open in the front:
Super capacity for more clothes
Pulsator type for wash efficiency, twist free and low wear
2

SPECIFICATIONS
Model HLT364XXQ GWT800AW
Free standing
Built under ××
EAN code --- ---
Energyefficiency class
Technical data
Was h capac ity kg 10.0 10.0
Spin capacity kg 10.0 10.0
Level/Vol ume
L
1/28L 2/36L 3/49L 4/54L 5/61L 6/67L
7/73L 8/79L 9/89L 10/95L
1/28L 2/36L 3/49L 4/54L 5/61L
6/67L 7/73L 8/79L 9/89L 10/95L
Residual dampness %94% 94%
Voltage/ frequ ency V/Hz 120V/60Hz 120V/60Hz
Energy consumtpion kWh
Wat er cons umtpi on L
Was h power W400 400
Spin power W300 300
Voice p ower of was hing dB 53 53
Voice power of spinning dB
Net weig ht kg about79 about79
Gross weight kg about about
Contral mode l
Timer ××
contr aller ××
Normal comput erized
Fuzzy computerized
Frequen cy conver sion
Service features
Programs 86
Short cycle
Inlet h eating s elect
washin g and ri nse water temperu re selec tion
Spinning cycle (selector)
Spinning cycle (variable)
Start/Pause
Preset H2~24 2~24
Automatic balancing
Aesthetics(V.L.H.S.H.T)
Cabinet material P=Plastic/Z=Zincking/C=Cold ) ZZ
r drum (stainl. steel=s / plastic=p) SS
Drain type U=drain up D= drain down Drain up Drain up
Door (g lass= g / plas tic= p)
Adjus table f eet
Special function
inner cycle
Feet wheel ××
Double driver
Two-in-one with rinse and spin
Disinfect
Dimensions (measurements)
Height / built under mm 1080 1080
Width mm 686 686
Depth / with open door mm 686 686
Dimensions packed ( measurements packed)
Height mm 1180 1180
Width mm 766 766
Depth mm 756 756
20'Container load Sets 21 21
40’Container load Sets 45 45
40H’Container load Sets 90 90
NOTE: " " FOR AVALIABLE, "×" FOR NOT AVALIABLE “-”FOR NOT AVAILABLE,"-"FOR BE APPLICABLE,"V"FOR SQURE HIGH
HEAD,"H"FOR HAIF HIGH HEAD,"L"FORSQURE FLAT HEAD,"S"FORARC HIGH HEAD,"F"FOR ARC FLAT HEAD,"T"FOR TRANSPARENT
VIEW WINDOW.
3

SAFETY PRECAUTIONS
If the power cord is bad, to avoid risk it is required to replace it by the technicians
of our special shop or the after-sale service department. Keep the pin of the power
plug clean.
Do not share one receptacle with other
electric appliances. Do not use it in
case that the power plug is damaged
or the inserting into the receptacle is
loose.
Earth
Do not wash water-proof laundries such
as the raincoat, bicycle shelter etc. To
avoid abnormal vibration during spinning.
If the power cord is bad, to avoid risk it is required to replace it by the technicians
of our special shop or the after-sale service department. Keep the pin of the power
plug clean.
Be sure to earth the earthing wire reliably.
Do not put the machine at damp place like
the bathroom. Never wash it with water.
Do not let the machine share one receptacle
with other electric appliances. If the power
plug is damaged, or the plugging into the
receptacle is loose, do not use the plug any
more.
Do not install or store the washer where
it will be exposed to the weather.
The power cord plug should be convenient
to be pluged in or pluged out with hand
while the washing machine runs normally.
Be sure to pull the plug out and close the
water tap when the machine is idle,when
moving the machine,or when cleaning
the machine.Do not use wet hand to ins-
ert or pull out the power plug.
4

WARNING AND CAUTIONS
Do not decompose, repair or alter the
machine by yourself.
Do not stretch hands into the working
machine. It is dangerous even if the
rotation is slow. Take special care of
the children.
Do not put any hot or heavy items (such
as the kettle with hot water ) on the
washing machine.
The handicapped or children without
care shall not use the machine.
Under certain conditions, hydrogen gas may be produced in a hot water system that has
not been used for 2 weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot water
has not been used for such a period, before using the washing machine, turn on all hot
faucets and let the water flow from each for several minutes.
This will release any accumulated hydrogen gas. As the gas
is flammable, do not smoke or use an open flame during this time.
Keep the machine away from direct
sunlight and heat source like the heater.
Do not wash articles that have been
previously cleaned in, washed in, soaked
in, or spotted with gasoline, dry-cleaning
solvents, other flammable, or explosive
substances as they give off vapors that
could ignite or explode. Do not add
gasoline, dry-cleaning solvents, or other
flammable, or explosive substances to
the wash water. These substances give
off vapors that could ignite or explode.
Petrol
Thinner
5

Unit mm
NET DIMENSION
INSTALLATION AND ACCESSORY PARTS
The largest allowed slope of the shank base of the machine is 2 . The slanting or rough ground will
result in unstable running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal
Hang the plumb to confirm it's horizontal.
Adjust the adjustable feet
1) To twist the adjustable foot, please first lift up
the side of the foot slightly, and twist the foot.
2) Fasten the nut after adjustment.
Adjust the Installation position
High Low
Adjustable foot
<2
Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.
Shiping bar
Pull out
Pull the shipping bar out to avoid
damage to your washing machine
before your first use of it.
686
1080
686

INSTALLATION AND ACCESSORY PARTS
Usage of the drain hose
Hang the outer drain hose on the proper place
before washing( do not use it toppled down
on the ground).
Attend that the outlet of drain hose shall be higher
than the water level in washtub to avoid siphon
phenomenon.
1.0m<h<1.5m
Connect the water inlet hoses
Figure 2
Figure 1
C
H
1. Attach the water inlet hoses to the hot water faucet and the cold water
faucet. Using pliers, tighten the coupling. ( As figure 1)
4. Check for leaks
(1). Swing the water inlet hose gently to confirm if it is suitable.
(2). Turn on the water faucets and check for leaks. Asmall amount of water might
enter the washers. You will drain this later.
3. Attach the hose connected with hot water faucet to the HOT water inlet valve(sign
with "H'). Attach the hose connected with cold water faucet to the COLD water
valve(sign with C). ( As figure 2)
NOTE: Do not over-tighten.
2. Run water through both faucets and inlet hoses, into a bucket or laundry tub, to get
rid of particles in the water lines that might clog the inlet valves screens.
Install the drain hose
Outer drain hose
component Drain hose neck
Drain hose joint
Drain hose hoop
First install the drain hose hook on the parts of
outer drain hose component.
Put the drain hose clamp on the outer drain hose,
insert the outer drain hose into the joint for it, and
then clutch tightly with drain hose hoop.

Parts and function
Bleach injection inlet
Cabinet
Control panel
Control panel seat
Top lid
Adjustable foot
(four pieces)
Door switch
Front door
Inner tub cover
Power line
Water inlet valve
Drain hose joint
Back cover
OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS
Water level indicator will shut off if only Spin is selected.
Soak or Pre-wash will not work in the Cycles: Hand Wash,Quick Wash, Delicate
Casual and Wrinkle Control.