4
Warning
Do not use the headset while it is charging.
•If the battery is fully charged, the status LED (3) will go out.
•Disconnect all cable and mains connections after use.
Note
If you have not used the item for afew month, it may take 15-30
minutes for the status LED (3) to redwhen charging.
5.Operation
Switching the headset on/off
•Turn On:
With the device off,press and hold the multi-function key (1) for
3seconds until you hear ashort tone. The LED indicator (3) lights
up blue and avoice says, ‘Power On’.
•Turn Off:
With the device on, press and hold the multi-function key (1) for
5seconds until you hear along tone. The LED indicator (3) briey
lights up redand avoice says, ‘Power Off’.
The rst time the device is turned on, pairing is automatically started
–see 5.1
Bluetooth
®pairing.
5.1. Bluetooth®pairing
Note –Pairing
•Make surethat your
Bluetooth
®-capable terminal device is on
and
Bluetooth
®is activated.
•Formoreinformation, please refer to the operating instructions
of your terminal device.
•The headset and the terminal device should not be any further than
1metreaway from each other.The smaller the distance, the better.
•Ensurethe headset is off.
•Device off: Press and hold the multifunction button (1) for
approximately 5seconds until the status LED (3) begins to
alternate between redand blue and you hear avoice say,‘Pairing’.
The headset is searching for a
Bluetooth
®connection.
