HAMPTON BAY GFHD48 Manual

Instructions
& User’s Manual
Model No：GFHD48
FOR OUTDOOR USE ONLY.
KEEP THE INSTRUCTIONS FOR FUTURE REFERENCE.
For product warranty,please go to www.hamptonbay.com or call 1-855-HD-HAMPTON

2
WARNING
Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so
may r
SAFETY INFORMATION
• The installation of this unit must adhe re to local codes or either the National Fuel Gas Code, ANSI
Z223. 1/NFPA54, OR CAN/CGA-B149.1, National Gas and Propane Installation Code.
• THIS UNIT IS INTENDED FOR OUTDOOR USE ONLY! This product shall be used outdoors, in a
ventilated space and shall not be used in any enclosed a rea.
• This unit is to be used with p ropane gas only! (sold separately)
• Do not attach a remote gas supply to this unit.
• Only use propane gas for this unit.
• Do not use any solid fuel or charcoal for this unit.
• LP GAS WARNING: Do not use any more than 1/4in depth lava rocks/pumice stones/LavaGlass ™
• If the propane gas tank is leaking gas, you may hear, see, or smell a hiss. Do the following:
• Applying too much p ropane may result in gas pooling and will not bu rn. Allow fresh air into the unit
so that the remaining gas may escape.
• The max. inlet supply pressure: max. Gas supply 11 in w.c. (2.74kPa)
• Use LP propane tanks with the following dimensions: diameter 12 in, height 18 in - capacity 20 lbs.
• You must use a propane tank that has a collar to p rotect the gas valve.
• The tank system must be set up for vapor withdrawal.
• Discontinue use if any part of the p ropane tank is damaged. Rust and dents may be haza rdous and
should be inspected by a gas supplie r.
rocks/pumice stones/LavaGlass ™ could pop out and cause injur y. Should any rocks pop out, disca rd
them.
• Always ensure that lava rocks/pumice stones/LavaGlass ™ are completely dry befo re use. Failure to
do so will cause them to crack or pop.
• Do not operate unit until all parts a re fully assembled.
• Do not paint or color any part of this heating unit.
• Unit may be hot while in use, do not attempt to move it while in use.
• Never leave this heating unit unattended while in use.
• This unit is not intended for cooking.
• Keep a safe distance to avoid bu rning skin or clothing.
• Do not sit or rest hands or feet on this heating unit.
• Keep all electrical cords and fuel supply hose away f rom heated surfaces.
bowl.•

3
• Combustible material should not be within 72 inches of the top of the unit, or within 48 inches
around the entire unit.
• Keep the appliance area clear and free fr
vapors and liquids.
• ning, turn the gas valve off. Wait 5 minutes before repeating the initial
• Do not add water into the unit.
• Do not operate unit if any part has been under water. Immediately callaqualified service
technician to inspect the appliance and replace any part of the control system and any gas
control that has been under water.
• Do not disconnect any part while unit is in use.
• Do not store a spare propane tank on or near this unit.
• If the heating unit is indoors, detach the propane tank and leave outdoors.
• Always remove protective cover before operating (if applicable).
• Do not set the protective cover over the unit until it is turned off and completely cooled down.
• Check for leaks after not using the unit for long periods of time.
• Children should never operate this unit. Children must be supervised while near this unit.
• Keep gas tank at least 5 feet away from unit when lit. (if external tank)
• The maximum gas supply pressure is 250psi.
inspected annually and cleaned regularly.
• Inspect all elements of this heating unit before each use. If there is damage, the burner must be
replaced.
• Keep the hose out from any pathways to eliminate any accidental damage. (if external tank)
• Be aware of the hazards of high temperatures and stay away from the unit to avoid any burns or
injury.
of the U.S. Department of Transportation or the National Standard of Canada CAN/CSA-B339, LP gas
tanks, spheres and tubes for Transportation of Dangerous Goods; and Commission.
gas tank connection.
cks.
• Children and adults should be alerted to the hazards of high surface temperatures and should
stay away to avoid burns or clothing ignition.
• Young children should be carefully supervised when they are in the area of the appliance.
near the appliance.
• Any guard or other protective device removed for servicing the appliance shall be replaced
prior to operating the appliance.
may be required as necessary. It is imperative that the control compartment, burners and
circulating airways of the appliance are kept clean.
IF APPLICABLE:
• Allow heating item to cool completely before placing on lid.
• DO NOT use heating item while lid is installed. Always remove the lid while heating item is in use.

4
Only use the regulator and hose assembly provided with this unit.
Inspect the bur ner before use of this unit. If the bur ner shows any kind of damage, do not operate
the appliance.
NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas
valve is turned “OFF” before assembling. Do NOT attempt to assemble without proper tools.
SAFETY INFORMATION
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Combustible materials should not be within 72
inches of the top of the unit, or within 48 inches
around the entire unit.

5
Item Description Qty
A Lid
B Lava Rocks 1 box
C Body 1
D Tank Holder 1
E Battery 1
F Control Knob (preassembled) 1
G Electronic Igniter (preassembled) 1
CONTENTS
1
C
FG
H
A
B
E
D
H 4Adjust Foot
I 1Protective Cover for Gas Cylinder
I

6
ASSEMBLY INSTRUCTIONS
2. Check that the cont rol knob (F) for the gas
supply system is tu rned to the “OFF” position
before starting any assembly.
3. Put the 20 lb. propane gas tank (not included)
into the tank holder (D). Turn the wing screw on
the outside of the tank holder (D) clockwise to
tighten the tank into the tank holde r. D
Propane tank must be a minimum of 60 inches
away at all times.
DANGER
OFF
HI
F
1.Turn over the body(C) and assemble 4pcs
adjust feet(H) into bottom. H
C

7
5. Remove the rubber cap on the electronic igniter
(G) by unscrewing and slide battery (E) into the
battery slot. Make sure the positive side of the
battery faces outwards. Screw the electronic
igniter cap (G) over the battery tightly.
6. Remove the lid(A), and pour the box of lava
To ensure proper function, the guard on this
burner should be free of lava rocks at all times.
WARNING
E
G
CYLINDER VALVE
PRESSURE
RELIEF VALVE
BLEED-OFF
VALVE
BLACK COUPLING NUT
REGULATOR
turn clockwise to connect
turn clockwise
to reseal
4. Turn the cylinder valve on the tank
clockwise to close the p ropane tank.
Attach the p reassembled regulator
from the body (C) to the cylinder valve
by turning the regulator coupling nut
clockwise. Make su re it is fastened
securely and tighten connections by hand
only.
B
A
C
B

8
To Light
To Extinguish
Before performing a leak test, be sure that no sparks can occur and you a re in a spacious outdoor
area. Connect the propane gas tank to the regulator and turn the valve on the unit to the “o ff”
position. Brush a soap and water mixtur e on all connections. Turn the gas supply on; if bubbles
occur on any connection the re may be a leak. If you smell gas or a leak is discove red tu rn the
gas valve o ff, disconnect p ropane gas tank and do not use the appliance until the leak is
repai red.
Do not use the heating unit without inspecting the gas hose. If the re are signs of wear or abrasion
you must replace the hose (if applicable). Pumice stones/lava rocks/LavaGlass could pop up and
20 minutes after igniting. Flame height should be a yellow/blue color between 2 - 10 inches in height.
heating item.
1. Make sure the control knob (F) is in the “off” position. Slowly open the valve on the p ropane gas
tank by turning the knob counte rclockwise.
2. Push and hold in the electronic ignit r (G) to create sparks within the elect rode, continue to hold.
3. Push in the control knob (F) and turn to the “low” position. Keep holding down the cont rol knob
5 seconds.
4. If ignition doesn’t occur within a few seconds , release the control knob (F) and rotate to the “OFF”
position. Wait for 5 minutes for gas to clear and then repeat the above lighting instructions.
5.
between the “low” and “high” positions.
1. Turn control knob (F) clockwise to the “low” posi
the control knob (F) to the “off” position.
2. Close the cylinder valve on the propane gas tank if you don ’t intend to use it for a long time.
OPERATION
Fire product and p ropane gas cylinder minimum
distance must be over 60 inches (as per right side
photo)
WARNING
60”
tion; let the knob pop up and continue turning

9
MAINTENANCE
• Before performing any maintenance always disconnect propane gas tank.
• Keep the heating item free and clear from combustible materials.
• Visually inspect burner for obstructions and keep tank enclosure free and clear from debris.
• Use a soft brush to get rid of the mild stains, loose dirt and soil after the burner and pumice stones/
lava rocks/LavaGlass™ are completely cooled down. Wipe down with a soft cloth.
• Harsh weather conditions may cause stubborn stains, discoloration and possibly rust pitting.
• Permanent damage may occur if powder or solvent comes in contact with painted or plastic
components on this heating unit.
• Keep the heating unit stored away from direct sunlight.
• If storing this unit inside, disconnect the propane gas tank from the gas valve.
• Not using manufacturer approved or supplied parts/accessories may result in a defective condition
and void the warranty of this heating unit.
• Always place lid (if applicable) or protective cover on heating item when not in use.

10
TROUBLESHOOTING
Problem Cause Solution
Igniter pin and burner are wet Dry off with a soft cloth
Igniter battery is incorrectly inserted Check which direction the battery is
inserted
Igniter pin is broken Contact Bond Manufacturing for a
replacement part
Electrode wire is loose or disconnected Reconnect wire to the igniter box located
inside the fire table behind the igniter box
Electrode wire is shorting between valve
and igniter pin
Contact Bond Manufacturing for a re-
placement part
No gas flow Check that the gas tank isn’t empty
Regulator isn’t connected securely to the
tank
Tighten regulator connection to the gas
tank
Gas flow is obstructed Check all hoses for kinks and bends
Burner ports are clogged Turn all gas flow connections off. Insert
an opened paperclip (or similar item) into
each of the burner ports to clear them
out.
Flame is obstructed at burner ports Check that all burner ports are free of any
small lava rocks/pumice stones/Lava-
Glass™ pieces
Regulator hose is kinked Straighten hose of all bends or kinks
No gas flow Check that the gas tank isn’t empty
Excess flow safety valve has been
activated
Turn the control knob to the ‘off’ posi-
tion. Close the tank valve and disconnect
propane gas tank. Turn the control knob
to ‘high’; wait 1 minute. Turn the control
knob back to the ‘off’ position. Recon-
nect propane gas tank. Light the fire unit
as indicated in the ‘To Light’ section of
this manual.
High or gusting winds Increase flame to ‘high’
No gas flow Check that the gas tank isn’t empty
Excess flow safety valve has been
activated
See ‘sudden drop in gas flow’ above
Heating unit won’t light
Burner won’t light
while using a match
Heating unit emits a lot
of black smoke
Sudden drop in gas
flow
Flame blows out easily

11
Repair gas passages and associated components should be done only by a qualified service
person.
Caution: Always allow heater to cool before attempting service.
CARE AND MAINTAINCE
Service:

12