Harken 3282 User manual

INSTRUCTIONS
3282 Floating Jib Lead Ring
WARNING! Strictly follow all instructions to avoid an accident, damage to your
vessel, personal injury or death. See www.harken.com/manuals for additional
safety information.
USA –Tel: [phone] • Web: www.harken.com • Email: [email protected]
Italy –Tel: [phone] • Web: www.harken.it • Email: techser[email protected]
Features
Weight saving alternative to blocks - simple, weight-saving used to route line for
floating jib leads in-haulers, and twings
Machined 6061-T6 Aluminum - for durability and corrosion resistance
Hard-Lube anodized - provides slippery durable surface
Terms
1
Jib lead throat
Adjuster line channel
Dimensions
Dowel pin
Maximum adjuster line diameter 7 mm
(9/32")
18 mm
.71"
49 mm
1.94"
42 mm
1.64"
25 mm
.97"
8 mm
.31"

Application
2
Maintenance,Inspection, and Storage
Periodically inspect components for wear, corrosion, and loosening. Replace as
necessary. Clean and inspect:
Fairlead and dowel pins
Adjuster line and splices
Frequently flush with fresh water. Periodically clean
with mild detergent and water solution. Flush with
fresh water. Avoid exposure to teak cleaner and other
caustic solutions.
Clean fairleads as above before storage. Store in a dry location.
M1024 08-18
Warranty
For additional safety, maintenance, and warranty information see www.harken.com/manuals or the
Harken catalog.
Pass adjuster line through channel under dowel pins. Pass sheet through throat.
McLube®Sailcoat™ may be used to make the surface more slippery.
McLube is a registered trademark of McGee Industries, Inc.
SailKote is a trademark of McLube®, a Division of McGee Industries.
WARNING! Do not spray ring while it is on boat. McLube Sailkote
overspray will cause slippery decks which may result in loss of footing,
falling overboard and personal injury or death.