Harken Crossbow 2758.1.1M.20 User manual

Printed in USA 5028 04/14
INSTRUCTIONS
Crossbow™Pivoting Self-Tacking Jib Track System
2758.1.1M.20 2758.1.1M.50 2758.950MM.20
USA –Tel: [phone] • Web: www.harken.com • Email: [email protected]
Italy –Tel: [phone] • Web: www.harken.it • Email: techser[email protected]
No. Part No. Description Qty
H-62502 Car Assembly
1 HFS1068 Locking Nut - M4 x .7 1
2 AL-1211 Car Body Half 2
3 MP-122 1/4" Delrin®Ball 4
4 MP-117 3/16" Torlon®Ball 42
5 MP-1964 Race Endcap 2
6 H-62282 Sockethead Cap Screw M4 x 0.7 x 20 mm SHCS 1
Beam / Deck Mounting pads
7 MS-002 Retaining Ring 3
8 SP-035 Clevis Pin - 3/16" X 1.375" 3
9 H-63163 Stamped Anchor 3
Track Assemblies
10 H-63456 Track Assembly - 1100 mm L x 20 mm H 1
11 H-64895 Track Assembly - 950 mm L x 20 mm H 1
12 H-63457 Track Assembly - 1100 mm L x 50 mm H 1
1
2
3
3
45
6
7
8
9
Parts List
Maintenance
3/16", #10, 5 mm
H
Part No. H L
2758.950MM.20 20 mm 950 mm
2758.1.1M.20 20 mm 1168 mm
2758.1.1M.50 50 mm 1168 mm
L
Flush balls and track hinges with liquid detergent and fresh water.
Once dry, use a single drop of OneDrop™in each ball race.
10, 11
12
20 mm
50 mm
Delrin®Delrin®is a registered trademark of E. I. du Pont de Nemours and Company or its affiliates.
OneDrop™OneDrop™is a trademark of McLube™, a Division of McGee Industries.
Teflon®Teflon®is a registered trademark of E. I. du Pont de Nemours and Company or its affiliates.

Mounting Removing Car (Continued)
Removing Car
2
1
Use straight edge or chalk line to insure mounting holes are lined up.
Before removing car, press sides of car together
to ensure race endcap will hold balls in place.
If race endcap is not pressed
into place, balls will escape.