Harman AKG LC 617 User manual

QUICK
START
GUIDE
LC 617
Read carefully before use
LC 617 Mounting LC 617 Positioning AdapterMounting Cleaning
Download cutsheet with technical details
from: www.akg.com
For CE certificates contact: @akg.com
This product conforms to the standards
listed in the Declaration of Conformity.
01/17/5079105_B
Printed in EU
• To clean the microphone
surface, use a soft cloth
moistened with water.
• Clean the foam
windscreen in mild soap
suds. You can use
the windscreen again as
soon as it has dried.

Trouble Shooting
Problem Possible Reason How to Solve
No Sound:
Europe:
AKG Acoustics GmbH
Laxenburger Strasse 254
A1230 Vienna - AUSTRIA
Tel.: [phone]
[e-mail]
USA:
AKG Acoustics, U.S.
8500 Balboa Blvd. Dock 15
Northridge, CA 91329, USA
Tel.: [phone]
[email protected]
necessary.
Distortion:
Also read the transmitter and receiver manuals!
RISK OF DAMAGE
Please make sure that the piece of equipment your microphone will be When scrapping the equipment, separate the case, circuit boards and cables and dispose all
components in accordance with local waste disposal rules.
The packaging of the equipment is recyclable. Dispose packaging in an appropriate containe. r
provided by the local waste collection/ recycling entity and observe all local legislation relating
to waste disposal environment and recycling.
1. Power to mixer and/or
amplifier is off.
2. Channel or master fader
on mixer, or volume
control on amplifier is at
zero.
3. Microphone is not connected
to mixer or amplifier.
4. Cable connectors are
seated loosely.
5. Cable is defective.
6. No supply voltage.
1. Switch power to mixer or
amplifier on.
2. Set channel or master
fader on mixer or volume
control on amplifier
to desired level.
3. Connect microphone to
mixer or amplifier.
4. Check cable connectors
for secure seat.
5. Check cable and
replace if damaged.
6. Switch phantom power on
6a. Check cable and replace if
1. Gain control on the
mixer set too high.
2. Mixer input in overload
1. Turn gain control down CCW.
2. Connect a 10-dB preattenuation
pad between
microphone and mixer