Hasbro The Clone Wars AEGS 5+ User manual

x3
BATTERIES INCLUDED
1.5V A A/R6 size
Replace with 3 x 1.5V “AA” or R6 size
batteries. Alkaline batteries recommended.
Phillips/cross head screwdriver (not included)
needed to replace batteries.
BATTERIES REQUIRED
1.5V A AA/R03 size
Alkaline batteries recommended.
Phillips/cross head screwdriver (not
included) needed to insert batteries.
NOT INCLUDED
x3
AGES 5+
87845
IMPORTANT! PLEASE READ INSTRUCTIONS
COMPLETELY BEFORE WEARING TOY.
Helmet:
Light:
This is not a protective device.
This is not a protective device.
Light is not a flashlight.
CAUTION:
Light is not a flashlight.
CAUTION:
ASSEMBLY & STRAP ADJUSTMENT
1
1
2
Attach straps to helmet
front: Insert tabs into holes
on inside of helmet and slide
up towards top of helmet.
Make sure all four mounting
points are secure. Attach upper and lower
halves of helmet back.
Attach crest to
helmet back.
Attach helmet back
to helmet front.
1
3
4 5
2
Adjust straps to fit child’s head.
Straps can be readjusted once they
are attached to helmet. To adjust, lift
straps off posts, slide straps to desired
position, and press straps onto posts.
Attach light to
helmet as shown.
6

Place helmet straight down on
head. Make sure the straps are
adjusted to keep it steady on
the child’s head so your child
can see through the eyes.
WEARING HELMET
BUTTONS
When helmet is not in use, slide switch
to “Off” to help conserve battery life.
Power
Radio Static Button/Voice Amplifier
Clone Trooper Phrases Button
Clone Trooper Commands Button
BUTTONS (CONTINUED)
Clone Trooper Commands Button: Wearing the
helmet, press the button to hear clone trooper
commands from Star Wars entertainment.
The commands are:
Green light! Go! Go! Go!
All forward positions are advancing.
Come on, hurry, hurry!
Get ready to turn those clankers into scrap metal.
Cover me.
All units, fire at will!
We’ve got you outnumbered.
Radio Static Button: Wearing
the helmet, press the button
to activate radio static sounds
and voice amplification. Speak
your own commands to create
realistic-sounding clone trooper
radio “chatter.”
Clone Trooper Phrases Button: Wearing the
helmet, press the button to hear clone trooper
phrases from Star Wars entertainment.
The phrases are:
Roger that, sir.
I’m on my way.
I’ve got a bad feeling about this, sir.
The mission always comes first, sir.
Gunships are holding at a safe distance.
The droid army is in full retreat.
All clear, General.
Sir, we’re taking heavy fire.
Slide switch to
activate light.
23
The helmet comes packaged in a “try me”
mode. Move switch from “Try Me” position to
“On” position for full activation of features.

CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to insert item
correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it away from
other electrical equipment. Reset (switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always remove
from the product before recharging. Recharge batteries under adult supervision. DO NOT
RECHARGE OTHER TYPES OF BATTERIES.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy and battery
manufacturers’ instructions;
2. Do not mix old batteries and new batteries or alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT:BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
TO REPLACE BATTERIES
TO REPLACE HELMET BATTERIES
BATTERY INSERTION
FOR LIGHT
5
4
1 2
3
Remove crest
section over battery
compartment door.
Loosen screw in battery
compartment door with a Phillips/
cross head screwdriver (not
included). Remove door. Remove and
Loosen screw in battery
compartment door with
a Phillips/cross head
screwdriver (not included).
Remove door. Remove and
discard batteries. Insert 3
x 1.5V “AAA” or R03 size
batteries. Alkaline batteries
recommended. Replace
door, and tighten screw.
discard batteries. Insert
3 x 1.5V “AA” or R6
size batteries. Alkaline
batteries recommended.
Replace door, and
tighten screw.
Re-attach crest to
helmet.

Product and colors may vary.
© 2008 Lucasfilm Ltd. & ® or TM where indicated. All rights reserved.
®* and/or ™* & © 2008 Hasbro. All Rights Reserved.
™ & ® denote U.S. Trademarks. P/N 6797020000
*
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy, and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to insert them
correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries, or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it away from
other electrical equipment. Reset (switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries. Always
remove from the product before recharging. Recharge batteries under adult supervision. DO NOT
RECHARGE OTHER TYPES OF BATTERIES.
8. As with all small items, these batteries should be kept away from children. If swallowed, seek
medical attention immediately.
CAUTION: TO AVOID BATTERY LEAKAGE
1. As with all small batteries, the batteries used with this toy should be kept away from
small children who still put things in their mouths. If they are swallowed, promptly
see a doctor and have the doctor phone [phone] collect. In other countries,
have the doctor call your local poison control center.
2. Make sure the batteries are inserted correctly and always follow the toy and battery
manufacturers’ instructions.
3. Do not mix old and new batteries, alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
IMPORTANT:BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
6