Haworth Hop Single-Stage User manual

Operating Your
Height-Adjustable Table
NOTE: Avoid risk of injury with your height-
adjustable table through proper training. For safe
operation, ensure that there is at least 1" between
the height-adjustable worksurface and any adjacent
objects such as storage or fixed worksurfaces.
(except for Hop®Single-Stage Table)
1

Switch Type
Your table is equipped with one of two switch types
(programmable or standard up/down).* Use the up
and down arrows and follow the instructions regardless
of switch type.
*Switch and table examples are for illustration
purposes only—yours may look different depending
on table type.
PROGRAMMABLE
STANDARD UP/DOWN
1 4
S
23
2

Default Reset
Synchronizes motors by returning the table to lowest
position. Resetting resolves most mechanism issues.
Perform this step once a month, when legs are
uneven or not raising.
1. Press the down arrow on switch.
2. Bring table all the way down.
3. Release button.
4. If you’ve already programmed a storage stop (see
page 4 or 5), you will need to continue holding the
down arrow past the storage stop position.
5. Hold down arrow again for 10 –15 seconds until
table moves down, then up slightly (about 1/2"
distance).
1 4
S
2 3
1 4
S
2 3
2
1THEN UP
SLIGHT
LY
MOVE
DOWN
3

1 4
S
“HOLD”
2 3
Set or Clear Lower Storage Stop
Prevents table from colliding with lower storage
components.
To set, table needs to be in the lower half of its
adjustment range.
1. Lower the table to the desired height.
2. Press and hold both up and down arrows
simultaneously until you hear two clicks
(about 10 seconds).
To clear, adjust the table to the desired height, press
and hold both up and down arrows simultaneously
until one click is heard (about 10 seconds); the table
can then travel to its lowest range.
1 4
S
“HOLD”
2 3
1 4
S
2 3
1) “CLICK”
2)“CLICK”
1) “CLICK”
29”
29"
4

1) “CLICK”
2)“CLICK”
1) “CLICK”
1 4
S
“HOLD”
2 3
1 4
S
1 4
S
“HOLD”
2 3
42”
42"
Set or Clear Upper Storage Stop
Prevents table from colliding with upper storage
components.
To set, table needs to be in the upper half of its
adjustment range.
1. Raise the table to the desired height.
2. Press and hold both up and down arrows
simultaneously until you hear two clicks
(about 10 seconds).
To clear, adjust the table to the desired height, press
and hold both up and down arrows simultaneously
until one click is heard (about 10 seconds); the table
can then travel to its highest range.
2 3
5