Takara Belmont EX-ESYMZ User manual

1
Shower Head Holder with Drainer
2021.05 Version 2
No.1E07Q7A0
TAKARA BELMONT SHAMPOO EQUIPMENT
Thank you for purchasing this Takara Belmont product.
The instructions contained in this booklet should be thoroughly read and understood before use.
Using this product before reading this operating instructions may result in an accident.
This product is an industrial shampoo unit designed for barbers and hair salons. Only use this product
for its intended purpose and do not use it for non-hairdressing work.
Keep this instruction and refer back to them when required.
For installation and assembly of this product, contact your local Takara Belmont dealer.
Image is EX-ESYMZ/SC-ESBL/SU-ESBL/EA-ESBP
Operating Instructions

2
Table of Contents
Introduction
Preparation
How to Use
Maintenance
Description of Warning Symbols ................................................................................................... 3
Safety Precautions .......................................................................................................................... 3
Precautions for Use ........................................................................................................................ 4
Name of Parts .................................................................................................................................. 4
Remove the cover ............................................................................................................................ 5
Sponge Installation ......................................................................................................................... 5
Installation of the Cover ................................................................................................................. 5
Using the Shower Head .................................................................................................................. 6
To Fill up the Basin with Water ..................................................................................................... 7
Maintenance ..................................................................................................................................... 8
Before Requesting Repairs .......................................................................................................... 10
Daily Inspections ........................................................................................................................... 10
Consumable Supplies ................................................................................................................... 10
2
When Necessary

3
Description of Warning Symbols
Precautions for Use/Maintenance
The "Safety Precautions" and "Precautions for Use" contained in this booklet should be thoroughly read
and understood before use.
■Before using this product
The precautions listed here are to ensure that this product can be used safely, and to prevent any
danger or risk to the person using this product or those around them.
These precautions are important for ensuring safety. Adhere to these precautions at all times. Takara
Belmont is not responsible for any damage or risk to the person using this product or those around
them due to accidents if this product is used without adhering to the "Safety Precautions" and
"Precautions for Use". In this case, the person failing to adhere to the "Safety Precautions" and
"Precautions for Use" will be responsible for any damage or risk incurred.
Detailed descriptions of symbols are provided below. Read and understand these symbols thoroughly
before reading this instruction.
■Precautions listed here
If this symbol is ignored and the product is used, "there is the risk of death
or serious injury to the user".
If this symbol is ignored and the product is used, "there is the risk of light or
moderate injury or physical damage".
Classification Level and urgency of harm or damage
The specific points that are to be abided by are explained using the following symbols.
Symbols of prohibited matter
Common prohibited actions
Warning
Caution
Safety Precautions (Adhere to these precautions at all times)
Caution
●Do not turn the water fully on with the shower head in the shower head holder.
Failure to follow this instruction may cause water to spill out of the basin, covering the
customer with water. When turning the water on with the shower head in the shower head
holder, check the surrounding area and turn the tap slowly.

4
Name of Parts
●Do not collect water until it overflows from the shower hose slot.
The amount of water should be below the designated maximum water level. [Page 7]
Cover
Sponge
Sponge holder
Shower head
holder
Precautions for Use
●Do not cover the drain outlet when this product is not in use.
Do not cover the drain outlet with the drain cap, towel, or shampoo cloth after finishing use.
Water may overflow when water is improperly discharged or a small amount of hot
water is discharged due to an increase in water pressure during the night, resulting in water
leaks. Be sure to remove the trap cover from the drain outlet when the product is not in use.
●Return the shower head to the shower head holder so that the shower head plate faces the basin
Failure to follow this instruction may cause water to spill out of the basin or splash the customer
with water.
●Do not remove the cover of holder forcibly.
Failure to follow this instruction may cause damage to the product.
●Put shower head securely into the holder.
Failure to follow this instruction may cause water to spill out of the basin, covering the
customer with water.
●Do not leave the shower head immersed in water.
If pressure in the water pipes decreases due to repairs that follow water stoppages, the water in the
basin may flow back through the shower head.
●Do not wet the shower head holder with water.
Failure to follow this instruction may cause water leaks.

5
Remove the Cover
Sponge Installation
１Turn the cover counterclockwise.
Turn the cover around 5 degrees.
【Image】
２Pinch the front and back of the cover to
deform and remove the catch.
Catch
Cover
Attach the sponge to the shower hose.
Attach the sponge and sponge holder to the shower
hose, between the shower head holder and the cover.
Installation of the Cover
Align groove in the cover and protrusion of the holder until they snap into place.
Protrusion
Sponge
Cover
Sponge holder
Shower head
holder
Do not remove the cover of holder forcibly.
Failure to follow the instruction may cause damage the product.
Caution
Ensure that the harder side of
sponge is facing upwards.
Caution
Note: Harder side of sponge to be
facing upwards.

6
Shower head holder Shower head holder
Shower head holder
Using the Shower Head
Changing the selection switch position switches between Shower Mode and air Low-splash Mode.
Shower head
Selection switch
Shower head plate
Low-splash mode
water outlet
<Shower Mode> <Low-splash Mode>
Press the switch on the
side with the protrusion.
Press the switch on the
flat side.
Protrusion
Water Outlet
Spa-shower headSpa-shower head
Shower head
Shower head plate Shower head plate Shower head
Water outlet
Water outlet
YUME shower headYUME shower head Side shower headSide shower head
Caution
- Do not discharge a strong water stream when the shower head is in the shower head
holder. Failure to take this precaution may result in system failure due to spilled water
or damage to the floor.
- Return the shower head to the shower head holder after use so that the shower head
plate is pointed toward the basin.

7
Designated maximum
water level
To Fill up the Basin with Water
Drain cap
Shower hose hole
Shower hose hole
Drain cap
The drain is closed.
The drain is open.
Clockwise Direction
Anticlockwise Direction
<Filling the basin>
<Discharging the water>
Drain cap
To fill the basin with water, rotate the drain cap in
the clockwise direction to close the drain outlet. The
amount of water should be below the level shown
by the dotted line in the illustration below (just
below the shower hose slot).
When water accumulates and exceeds the dotted
line, water may overflow from the shower hose slot.
To drain the water, rotate the drain cap in the
counterclockwise direction to open the drain outlet.
The hot water may decrease slightly in an amount that will not affect use.
If the water level is decreasing significantly, the gasket of the drain cap may have deteriorated or become
worn. Replace the drain cap. (Available at additional cost.)
Caution
- The amount of water should be below the
designated maximum water level. (See right figure.)
- Do not leave the shower head in the water to ensure
that water doesn't leak out the shower hose slot.
Water may flow back into the water pipe which
could cause issues.
- When the drainage speed slows, there is a
possibility that dust and dirt may have clogged the
drainpipe.
- The drain cap must be detached from the drain
outlet when the product is not in use. If the drain
cap is not detached, the drain may accidentally
close, and the water may overflow from the failure
to notice water dripping, thus resulting in water
leaks.
For Back wash basin (YUME basin)For Back wash basin (YUME basin) For Side wash basinFor Side wash basin

8
Maintenance
Conduct the after-use care and always keep this product clean for later use.
Leaving dirt uncleaned may cause them to get moldy or smell.
Conduct dry wiping using a soft, dry cloth.
Resin component
For severe stains
Wipe using a soft cloth dipped in neutral detergent diluted ten times with water, then wipe with
water, then wipe with a dry cloth thoroughly.
Maintenance of various components
The metallic parts or mechanical structure of this product has sharp edges. Pay attention
to avoid hurting the hands or fingers when cleaning.
Caution
- Turn off the power switch and pull off the power plug when conducting maintenance.
There is a risk of electrical shock or ignition. Furthermore, an unexpected action of this
product may cause an injury.
- Do not splash water for washing. There is a risk of failure or electrical shock.
Warning
When restarting the use of this product after not using for a certain period, clean before using.
After cleaning, be sure to confirm normal operation of this product.
- Never use the following substances:
The volatile chemicals, such as thinner, alcohol, remover, gasoline, and kerosene, acid, alkaline or chloric
detergents, antiseptic solution strongly corrosive to metals (Providone Iodine, sodium hypochlorite, etc.),
waxes containing abrading agent, sponges containing abrading agent, etc.
- Do not use brushes, scrubbers, etc., for maintenance. It may leave scratches or stains.

<Remove>
<Attachment>
9
Push the socket to remove the cover.
Sponge
Sponge is consumable supply.
Replace the sponge if degradation causes rubbing sound
when the hose is moving. (Available at additional cost)
Remove the coverfrom the holder. [Page 5]
Cover
Replace the cover if it easily comes off repeatedly when the hose is moving. (Available at additional cost)
- Remove the sponge from the hose and wash with water.
- After washing the sponge with water, squeeze it like pressing
with both hands.
- Clean the sponge every day.
- After cleaning the sponge, put it in the hose and put it back on
the cover.
Remove the shower head.
(The figure on the right)
Remove the cover from the shower hose.
１
２
Install a new cover.
３
Shower head
Cover
Tips for installation.
Put the socket into a plastic bag and push the
cover to make it easier to enter.
Socket
Caution
- Please keep the sponge in the net.
If the sponge protrudes from the end of the net, return it to the net.
- Do not twist the sponge as it may damage the parts.
- Be careful not to mistake the direction of the sponge.
The harder side is above.
Maintenance
Cover
Sponge
Sponge holder
Shower head
holder
[Replacement method]
*Counterclockwise:
Removed

10
If the following problems occur, check the product before asking for repairs.
Symptom Check this Solution
The cover has come off.
When the hose is moved, it makes
a sound.
Attach the cover. [Page 5]
The sponge is protruding from the end
of the net.
The surface of the shower hose has
deteriorated and is rough. (The cover
and shower hose rub and make noise.)
Replace the cover if it easily comes off
repeatedly when the hose is moving.
If there is sound even though the sponge is in
the net, replace the sponge. (Available at
additional cost)
Replace the shower hose, if wiping the
surface of the shower hose with a wet towel
does not improve. (Available at additional
cost)
Before Requesting Repairs
Daily Inspections
Conduct the check below for safe use of the product.
Replace the sponge, if the smell of sponge becomes a
concern from outside the shower head holder.
(Available at additional cost)
There is a strange
odor from shower
head holder.
Check if there is a strange odor from
shower head holder.
Inspect item Inspection method If the inspection results show defects
Inspect the product every day.
Consumable Supplies
The following parts are "consumable supplies" and wear, degradation, changes in external appearance and
damage are expected.
Please note that repair or replacement of these parts is not covered by warranty, and a fee will be required.
(* The level and period of wear, degradation or damage may differ depending on the environment and
Consumable supplies (the following parts are not covered by warranty, and a fee will be required)
- Sponge - Cover