Hay STEFAN DIEZ BOA User manual

– INSTRUCTION MANUAL –
DESIGN BY STEFAN DIEZ
ALL SIZES
BOA TABLE

During assembly, place the parts of the frame and the table top
on a carpet to avoid scratches and other damage.


I Tabletop

B Crossbar x2

A Leg section x2
 PARTS 

 Only for connecting tabletops 

F Feet x4

G End cap x4

C Screw x4  L Washer x4
 PARTS 

D Allen key

N Torx bit

E Connector

J Latch x2

M Screws x8

K Connector x2

N Screws x8

H Screw
MOUNTING BAG 1
MOUNTING BAG 4
MOUNTING BAG 5
MOUNTING BAG 3

1.
Place the crossbars

B in the openings of the leg sections

A .
Make sure the small tabs in the crossbar openings are aligned as illustrated.
Two people are required to carry out the table assembly.

2.
Slide the crossbars towards the middle of the leg sections,
making sure they slide over the plastic insert.

3.
Rotate the crossbars away from the centre, so the small
tabs lock into the plastic insert.

4.
If your table has outlets, make sure to pull all cables
through the legs before going to the next step.

5.
Carefully bend the legs towards the centre.
Push down on the crossbars to keep them in place.

6.
Keep going until you hear a click.
This might require some extra force.

7.
Secure the legs with screws

C with the washer

L in between.
Carefully tighten it with the Allen key

D Avoid scratching the frame.

8.
Insert the feet. Align the tab with the cut-out in the leg.
Then turn the table over.

9.
If the floor is uneven, adjust the feet until the table is level.

10.
Place the connectors.

11.
Rotate the connectors towards the centre of the table so that they lock in place.
This might require some extra force.

12.
Insert the end caps. Make sure they are aligned with the holes as illustrated.

13.
Place the tabletop on top.
If you are connecting two tabletops, continue to step 15 after this.

14.
Align the cut-out with the two connectors.

15.
Align the tabletops, and push them together.
Make sure to insert the pins into the corresponding holes.
CONNECTING TWO TABLETOPS
If your table only has one tabletop, continue to step 20.