Heat Outdoors CH18A11W2 901698 Operation and maintenance manual

Shadow Peak
Infrared Patio Heater
Safety Instructions and Operation Manual
901698
Heat Outdoors
Unit 9, Stort Valley Industrial Estate
Stansted Road, Bishop’s Stortford
Hertfordshire, United Kingdom
CM23 2TU
www.heat-outdoors.co.uk
01279 466500
[email protected]

2
Contents
Brief Introduction . . . . . . . . . . . . . . . . . 3
Important Information . . . . . . . . . . . . . . . 3
Technical Specications . . . . . . . . . . . . . . 3
Safety Instructions . . . . . . . . . . . . . . . . . 4
Installation . . . . . . . . . . . . . . . . . . . . 6
Cleaning & maintenance . . . . . . . . . . . . . . 8
Customer Service . . . . . . . . . . . . . . . . . 9

3
Brief Introduction
Brief Introduction
This product is an infrared radiant heater with IP55 rating. This product can be used in
indoor and outdoor settings, such as hotel lobby areas, open bars, courtyards, shopping
centres, travel station, workshops, and construction sites in winter. This patio heater is
energy-ecient, convenient, environmentally friendly and for better life.
Important Information
Please carefully read all instructions provided before using this appliance. This heater
must be installed in accordance with the instructions and local regulations.
This Operation Manual contains the important information on your safety, as well
as some recommendations on the correct use, installation and maintenance of the
appliance.
When operating this infrared heater be sure to observe some precautions as improper
operation with disregard of precautions may result in iniction of harm to health of the
user and other people.
Ensure to keep this manual along with sales receipt, and if possible, cardboard package
and packing material in case return of the unit is necessary.
Technical Specications
Model No. CH18A11W2
901698
Voltage 230V-240V~, 50Hz
Power (W) 1800
Installation Wall
Product Dimensions
(mm)
596*135*300
Insulation Class I
Water Ingress Protection IP55

4Safety Instructions
Safety Instructions
Read these instructions before using.
WARNING
Potential re risk if the heater is covered by any matrial or positioned close to curtains or
other ammable materials.
• Use only the voltage specied on the rating plate of the heater.
• The heater should be connected to the electric mains equipped with an automatic
circuit breaker.
• The unit must be handled with care.
• Do not use the appliance areas where gasoline, paint or other ammable liquids are
used or stored.
• When using this heater in an area susceptible to dust such as building sites, barns
or stables, take extra care to clean the lamp to avoid build up of dust on the internal
element.
• Do not use the appliance as a sauna heater.
• Do not touch the radiating plate when the heater has been in use, wait for a
minimum of 30 minutes before touching any part of the heater. To avoid burns, do
not touch the appliance surface by hand and other body parts
• Do not place any items of clothing, hand towels or similar over the heater to dry.
• Do not leave the heater unattended whilst in use.
• Do not install this heater on a wet surface, or where it can fall or be pushed into
water.
• In the event the heater falls into water do not reach for the appliance. Switch off at
supply and unplug immediately.
• If the supply cord is damaged, it must be replaced by the manufacturer.
• If the heater is defective, it must be checked and repaired by the manufacturer, its
service agent or similarly qualied persons in order to avoid a hazard.
• Use this appliance only as described in this manual. Any other use is not
recommended by the manufacturer and may cause re, electric shock or injury.
• Do not use abrasive cleaning products on this appliance. Clean with a damp cloth
with hot soapy water only. Always remove plug from the mains supply before
cleaning.
• The heater must be installed at least 1.8 m above the oor.
• The heater must not be located immediately below a socket-outlet nor should the
socket-outlet located at the back of the heater. This should be located outside the
physical footprint of the units to minimize heat build-up behind the heater.

5
Safety Instructions
• If the heater is to be mounted on an incline (eg. Vaulted ceiling), ensure the
electrical connection is located at that lowest point of the heater.
• Do not operate with the cord coiled up as this could cause a build-up of heat, which
could pose a hazard.
• The use of an extension cord with this appliance is not recommended unless
purchased from the manufacturer with the heater.
• Do not run cord under carpeting, throw rugs or runners etc.
• Children under the age of 5 years should not be left unattended with the heater at
any time.
• Do not use appliance or any part of the appliance out of the intended use to avoid
risk.
• The use of attachments which are not recommended or sold by the appliance
manufacturer may cause a risk of injury to persons.
• Install and operate the heater in strictly horizontal position on the ceiling or ceiling
structural elements. At that, thermal resistance of the ceiling coating material
should be at least 80 °C.
WARNING
This heater is not equipped with a device to control the room temperature.

6Installation
Installation
Safe distances required for installation
Attention:
Install the heater at a minimum distance of:
• 1.8 m above the ground
• 0.5m from walls
• 0.2m from the ceiling
• 1.5m from the combustible materials like curtains
• 1m from people or animals

7
Installation
Installation Procedure
Take every precaution to ensure that the suitable clearance is given to the heater as
described in the previous section.
1. Mark the pilot holes on the surface where the heater will be installed using the
measurements provided or directly using the wall-mounted bracket.
2. Attach your chosen xings through to x the wall-mounted bracket the wall.
3. Attached the heater according to the diagram with the supply heater xing parts.
4. Directly plug your heater into the mains supply or hard wire into a circuit board,
the heater will automatically turn on once the power supply is ON. (If this does not
happen, contact Heat Outdoors to run through troubleshooting.
Contact us to acquire our innovative control boxes for optimum comfort and performance
from your installation.
Part no. Part name Qty
①Heater 1
②Butterfly nut
M6 2
③Spring washer
Ф6.2mm
2
④Machine Screw
M6*16mm
2
⑤Wall-mounted
bracket
1
①③
②
④
⑤
185 mm
40 mm

8Cleaning & maintenance
Cleaning & maintenance
Heater housing, grills and internal refl ector
• Disconnect the appliance from the power supply system.
• After the appliance has cooled down, the housing can be wiped clean with warm
soapy water using a damp cloth.
• Do not touch the bulb element with your  ngers, since stains could build up from
such a contact and may cause malfunction of the blub.
• Do not use any abrasive or hard cleaning products on any part of this heater.
• Do not immerse the appliance in water.
Cleaning of heater lamp
• Disconnect the appliance from the power supply system.
• Wipe the lamp over with a damp cloth ensure no detergents or cleaning  uids are
used as they may cause damage to the lamp coating.
https://www.heat-outdoors.co.uk/help-desk/useful-articles/heater-and-lamp-
maintenance.html
Any maintenance or repairs should only be carried out by a quali ed electrician if you’re
unsure how to do so. For further information and guidance, visit our online help aerticles
and videos.
Disposal
In accordance with European Directive 2001/96/EG concerning used
electrical and electronic appliances (waste electrical and electronic
equipment – WEEE), please return any electrical equipment that you will no
longer use to the collection points provided for their disposal.
This symbol indicates that the appliance cannot be treated as normal
domestic trash, but must be handed to a collection point for recycling electric and
electronic appliances.
Information concerning where the equipment can be disposed of can be obtained from
your local authority.

9
Customer Service
Customer Service
• Repairs must be carried out by authorized specialists, thus ensuring electrical safety.
• Please contact us or a suitably qualied electrician.
• Improper repairs could lead to danger to the user.
Warranty does not cover damage of failure which results from alteration, accident,
misuse, abuse, neglect, commercial use or improper maintenance. In line with our policy
of continuous product development we reserve the right to change the product and
documentation specications without notice.

10 Customer Service

11

Heat Outdoors
Unit 9, Stort Valley Industrial Estate
Stansted Road, Bishop’s Stortford
Hertfordshire, United Kingdom
CM23 2TU
www.heat-outdoors.co.uk
01279 466500
[email protected]